Hitachi 42HDF39 Operating Manual page 38

SETTING UP YOUR DTV
Manual Scan
Note: It's suggested that you to contact the antenna Installer when you have to trouble of locking the signal.
Edit
Note: When the blocked channel has selected, the program can not be showed, and you will get the message "Channel is
blocked" from TV
1. On the Channel menu page, select the third item MANUAL SCAN.
2. Press or to highlight the input column. Then press numeric buttons to input
the channel number. The channel frequency will be automatically showing on
right side of the input column.
3. Press OK button when the message "Add channel" and "press Enter to add
channel" has shown.
4. If the ATSC signal is found and locked, the Status will show message "Get No.
XX 8VSB channel success". Then you can press EXIT to leave the menu page
and watch the program, or go ahead scanning the other channels.
5. If the signal is not locked, the status will show "Got No Channel". You can scan
the signal again or refer to the signal level bar "Signal" for aligning the direction of
the antenna to get the signal.
6. When the signal is locked and the receiver is on the channel, you can enter into
this page to check the signal level.
1. On the Channel menu page, select the first item EDIT.
2. Press ▲▼ and buttons to highlight the channel's BLOCK or FAV control
column and press OK to block channel or copy channel into the favorite channel
list "F1".
3. After the edit setting, press the EXIT button, then will pop up a confirmation
window: choose "NO" to cancel the edit change; choose "YES" to save the edit
settings.
37