Polaris CR 0612B Manual Instruction page 12

IV. Before first use
The installation of roller-legs
Follow the instruction guide to install properly the
roller-legs. Join the first roller-leg and the axe as
shown in the picture (figure 3).
 Join the second roller-leg (figure 2).
 Turn over the radiator to have access to bottom panel.
Install the bracket (figure 5).
 Join together the bracket and the roller-leg axe (figure
6 and 7).
 Screw the nut tight as shown in picture 7.
 Turn back the radiator. Make sure that roller-legs are
screwed tightly (figure 8).
 Push slightly the front leg to install. Use the screw to
join it tightly (figure 9).
Note!
The radiator should always be placed in vertical position to reduce the risk of overheating, fire or electric
shock.
V. The radiator operation
Make sure that the horizontal surface on which the radiator is placed is firm and steady and there
are no any inflammable objects in the distance of 1 metre.

Before plugging the device in outlet, please make sure, that the power control is in the "0"OFF position
and the thermostat control in the "MIN" position.

Please rotate clockwise the thermostat controller up to «MAX» position. Use the power regulator to
choose the required temperature: I position – low power, II position – medium power and III position –
high power.
Fig. 7
Figure 3
Figure 5
Fig. 8
Figure 4
6
Figure
Fig. 9