Chapter 3 Appendix - Gigabyte B450M GAMING User Manual

Chapter 3 Appendix
RAID Levels
Minimum Number of
Array Capacity Number of hard drives *
Fault Tolerance
Before you begin, please prepare the following items:
Windows setup disk.
Motherboard driver disk.
A USB thumb drive.
A. Installing SATA hard drive(s) in your computer
from your power supply to the hard drives.
Steps:
1.
Under Chipset, ensure Chipset SATA Port Enable is enabled. Set SATA Mode to RAID. Then save the
set NVMe RAID mode to Enabled
2.
The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.
Steps:
1. In BIOS Setup, go to BIOS and set CSM Support to Disabled. Save the changes and exit BIOS Setup.
2. After the system reboot, enter BIOS Setup again. Then enter the
Utility sub-menu.
3. On the
Array screen. Then, select a RAID level
Select Physical Disks to enter the Select Physical Disks screen.
drive.
RAID 0 RAID 1
No
- 37 -
RAID 10
2
Yes Yes
Array Management to enter the Create
4