Summary of Contents for Harman Kardon MP3 Docking Station
Page 1
THE BRIDGE II DOCKING STATION FOR iPod OWNER’S MANUAL 0057CSK - HK Bridge II All v10.indd 1 10/02/09 10:32:04...
Page 2
inTRODUCTiOn Congratulations! With The Bridge II, you are entering the new world of entertainment made possible by combining the incredible storage capacity and playback flexibility of an iPod with the sonic power of your Harman Kardon system. ® With a single cable, your iPod is connected, and all you need is your remote control to get started! Features •...
InstallIng With only a single cable connection, The Bridge II is easy to connect to your Harman Kardon product. step One: Turn off the Harman Kardon The Bridge- or The Bridge II-ready product, using its master power switch. step two: -Ready Products –...
OPERATIOn UsIng Once The Bridge II is connected, use either the front- panel controls or The Bridge-ready product’s remote control to select tracks for playback. Press the DMP/ The Bridge Button on the remote, or use the Source Selector on the front panel to change sources. When an iPod is docked, a message will appear in the front-panel and on-screen displays, indicating that The Bridge II is connected.
Charging the iPod You may leave your iPod in The Bridge II even when you are not using it as a playback source. Whenever the iPod is docked and your receiver is turned on, The Bridge II will charge the battery in the iPod. Some Harman Kardon receivers allow you to charge the battery in the iPod when the receiver is turned off (i.e., in the “Standby”...
TROUBLESHOOTInG tROUBlEsHOOtIng gUIDE sYMPtOM The iPod does not play or respond to commands from the receiver’s remote. The LED under The Bridge II goes out when the receiver is in the Standby mode. The display and controls on the iPod do not operate in iPod mode.
Page 7
STAPLE InVOICE HERE 0057CSK - HK Bridge II All v10.indd 7 10/02/09 10:32:33...