Specifications; Safety Warnings And Precautions - Harbor Freight Tools 43533 Set Up And Operating Instructions Manual

SPECIFICATIONS

Motor 120 V~, 60 Hz, 1.3 A
No Load RPM 0 to 10,000 RPM
Grinding Wheels 1- 3 x 3/4 inch Grinding Stone
1- 3 x 3/4 inch Fiber Wheel
Arbor 10 mm
Flex Shaft 31 inches long
Flex Shaft Collet 1/8 inch diameter
Flex Shaft Bit 1/8 inch mounting stone
Features Variable Speed Dial
Flex shaft wrench set
Note: Performance of this tool may vary
depending on variations in local line
voltage. Extension cord usage may
also affect tool performance.
SAVE THIS MANUAL
You will need the manual for the
safety warnings and precautions, assem-
bly instructions, operating and mainte-
nance procedures, parts list and diagram.
Keep your invoice with this manual. Write
the invoice number on the inside of the
front cover. Keep the manual and invoice
in a safe and dry place for future refer-
ence.
SAFETy WARNINGS AND
PRECAUTIONS
WARNING: When using tool, basic safety
precautions should always be fol-
lowed to reduce the risk of personal
injury and damage to equipment.
Read all instructions before using this
product!
1. Avoid working alone
happens, an assistant can bring help.
2. Disconnect power
not in use, before servicing and when
changing accessories such as grind-
ing wheels. Never walk away and
leave the tool running.
For technical questions, please call 1-800-444-3353.
SKU 43533
. If an accident
. Unplug tool when
3. Keep work area clean
areas invite injuries.
4. Keep children away
never be allowed in the work area.
Do not let them handle machines,
tools, or extension cords.
5. Store idle equipment
in use, tools must be stored in a dry
location to inhibit rust. Always lock
up tools and keep out of reach of
children.
6. Dress properly
clothing or jewelry as they can be
caught in moving parts. Protective,
electrically nonconductive clothes and
nonskid footwear are recommended
when working. Wear restrictive hair
covering to contain long hair. Wear
an ANSI approved dust mask or
respirator.
7. Use eye protection
ANSI approved impact safety
goggles.
8. Do not overreach
ing and balance at all times. Do not
reach over or across electrical cables
or frames.
9. Maintain tools with care
grinding wheels for cracks, and tool
cords periodically and, if damaged,
have them repaired by an authorized
technician.
10. Use the right tool for the job
not attempt to force a small tool or
attachment to do the work of a larger
industrial tool. There are certain ap-
plications for which this tool was
designed. Do not modify this tool and
do not use this tool for a purpose for
which it was not intended.
11. Stay alert . Watch what you are do-
ing, use common sense. Do not oper-
ate any tool when you are tired.
. Cluttered
. Children must
. When not
. Do not wear loose
. Always wear
. Keep proper foot-
. Inspect
. Do
REV 08j, 09e, 10a
Page 2