Table of Contents
Advertisement
When all the desired tracks have been programmed, press PLAY button to play the disc in the order you have programmed.
To stop the CD, press the STOP button.
Note: The program memory will be cleared only when the CD compartment is opened or turn off the CD or power supply.
To turn off the CD player set FUNCTION switch to TAPE (OFF) position.
Note: Good quality sound is guaranteed only when playing licensed discs.
Recording
Recording from radio
Set the FUNCTION switch to RADIO position.
Tune to the desired station by turning the TUNING control regulator.
Insert a blank cassette into cassette compartment.
Press the PLAY button and RECORD button on deck simultaneously to start recording.
Recording from CD
Set FUNCTION switch to CD (MP3) position.
Insert your cassette tape in the cassette compartment.
Activate the CD player.
Press RECORD and PLAY buttons simultaneously to start recording.
To stop recording temporarily, press the PAUSE button. To continue recording, press the PAUSE button again.
Press STOP/EJECT button when finished. Then stop CD playback by pressing the CD STOP button of the CD player.
You may want to monitor during recording. You can adjust the sound with VOLUME control regulator. These adjustments do not affect the content of
recording.
Maintenance and care
Check your batteries regularly, old or discharged batteries should be replaced. If the unit is not going to be used for some time or is being run exclusively
on the alternative power, remove the batteries to avoid leakage and damage.
Electronic products of this kind should never be subjected to moisture or extreme temperatures.
If necessary, clean the unit with a piece of cloth dampened with water only (be sure the AC power cord is disconnected from the power supply).
The heads and capstan are in constant contact with the moving tape. Use a small cotton bud with alcohol or special tape head cleaner to clean these parts.
Never touch the heads with anything metallic.
6
Advertisement
Table of Contents
