Installing The Batteries - Graco 1434 Owner's Manual

Installing the Batteries

Step 1.
With baby out of swing, open
the battery compartment lid by
inserting a coin (penny, nickel
or dime) into the coin slot. After
the lid pops open, swing it
down and remove it.
Step 2.
Insert four “D” cells. CHECK
that the batteries are put in
correctly. Your swing will not
run if the batteries are put in
backwards.
Step 3.
To replace lid, put the two
tabs of the lid into the two
slots in the bottom of the motor
housing. Swing lid up, and
press it into place until you
hear the latch click.
Starting the Swing
CHECK that all parts are securely fastened together
before using the swing.
Step 1.
Open tray and seat belt. Place baby in the seat. (If your
child is very small, you may want to use rolled-up blankets
as a prop.)
d.
Step 2.
Fasten the seat belt. Adjust
belt as needed to get a snug
fit around your child.
Step 3.
Close the tray. CHECK that
the tray is latched by pulling
up on the tray.
depend on the tray or seat
belt alone to hold your baby.
Always secure your baby
with both the seat belt and
tray when your child is in
the swing.
Coin
slot
Do not
11
Step 4.
To start swing, push the
desired speed button and give
the swing a gentle push.
•
Push “1” for the lowest ride.
•
Push “2” for medium ride.
•
Push “3” for the highest ride.
Observe the swinging motion for a minute. It takes time
for the swing to adjust to a setting. Change setting as
needed.
NOTE: A small, quiet baby will swing higher on each
setting than a larger, more active baby.
Step 5.
To turn swing off:
On models without music, push
the OFF button.
OR
On models with music, push
the active speed button.
Indicator light will go off and
swing will stop.
Indicator Light-
Red light comes on
when swing is turned on.
NOTE: SEAT MAY BE STOPPED ANY TIME MOTOR
IS RUNNING WITHOUT DAMAGING MOTOR.
PUSH SWING TO RESTART.
IF YOUR SWING MOTOR STOPS OPERATING
BY ITSELF, PROTECTIVE DEVICE MAY HAVE BEEN
ACTIVATED. TURN OFF MOTOR, WAIT 3 MINUTES,
THEN RESTART SWING.
To Use Music (on certain models)
If you want music for your baby, push the music button
until desired volume is reached:
•
Push once for high volume.
•
Push a second time for
•
medium volume.
•
Push a third time for low
•
volume.
•
Push a fourth time to turn
•
music off.
NOTE: The music control is independent of the speed
setting. You can have any combination of speed and
music settings.
12