Advertisement
Quick Links
Advertisement
Summary of Contents for WATSON Haven Neighborhood Light
- Page 1 ASSEMBLY Haven Neighborhood Light 360.394.1300 watsonfurniture.com V.21.0 10/2021...
- Page 2 Recharge Bench Components Shade Light Disc Stem Power Supply Bracket Power Supply 2 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS...
- Page 3 Housing Screw bench assembly) M4 X 12mm Tools Light Rod 60mm (used for bench and table sur face only) Light Rod 100mm (used for rail assembly only) Electric Drill Phillips Bit 13mm Wrench 3 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS...
- Page 4 (b.). Screw the light rod into the threaded plate in the light stem, and use the flat sections on the end of the light rod to tighten fully into the bottom of the lamp (c.). Light Rod 60mm 4 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS...
- Page 5 Place Light Stem Pass the cables through the hole in the table surface and insert the stem into the mounting hole. Position the stem so the alignment pins go through the alignment holes in the surface. 5 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS...
- Page 6 Pass the cables first through the mounting washer, then the lock washer, and last the mounting nut, and secure the stem to the surface by tightening the mounting nut to the light rod. Mounting Washer Locking Washer Mounting Nut 6 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS...
- Page 7 Attach Connector Housing Once you have secured the lamp stem, attach the connector housings onto the ends of the cables. Once inserted, gently pull on the wire to ensure a strong connection. Connector Housing 7 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS...
- Page 8 Plug the connector from the light disc into the connector from the stem (a.) and feed the excess cable down into the stem. Secure the light disc to the stem using (3) flat head screws (b.). Thread Cutting Screw M4 X 12mm 8 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS...
- Page 9 Secure the power supply bracket to the underside of the surface using (2) screws (a.). Slide the power supply into the bracket until it clicks into place. 10 X 3/4” Pan Head Screw (122875) 9 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS...
-
Page 10: Connect Power
Connect the plugs from the power supply to the connectors on the light, making sure to connect red to red and black to black. Secure excess cable to the surface using the supplied alligator clips to keep it out of the way. Plug into power source and test. 10 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS... - Page 11 Attach Light Shade Press the shade onto the light disc, applying even pressure around the perimeter until a snug and level fit. 11 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS...