Mitsubishi Electric SLH Series Technical & Service Manual page 54

4. FAN operation (Only SL-1, 1.6, 2AR)
ON/OFF
TOO TOO
WARM COOL
FAN SELECT
COOL
VANE TIME
FAN DRY
MODE
RESET
(1) Indoor fan control
The indoor fan speed LOW / MED./ HIGH depends on the remote controller setting.
5. AUTO MODE operation (Only SLH-1, 1.6, 2AR)
ON/OFF
TOO TOO
WARM COOL
FAN SELECT
AUTO COOL
VANE TIME
HEAT DRY
MODE
RESET
(1) lnitial mode
1 When AUTO operation starts after unit OFF.
If the room temperature is higher than the set temperature, operation starts in COOL mode.
If the room temperature is equal to or lower than the set temperature, operation starts HEAT mode.
2 When AUTO operation starts after COOL or HEAT operation, the previous mode continues.
(2) Mode change
1 HEAT mode changes to COOL mode when 15 minutes have passed since the room temperature became 2 degrees above
the set temperature.
2 COOL mode changes to HEAT mode when 15 minutes have passed since the room temperature became 2 degrees below
the set temperature.
6. TIMER operation
h
ON/OFF
ON/OFF TOO TOO
WARM COOL WARM
FAN SELECT
1
COOL
AUTO COOL
VANE TIME VANE
HEAT DRY FAN DRY
2
MODE MODE
RESET
SLH-1AR SL-1AR
SLH-1.6AR SL-1.6AR
SLH-2AR
SL-2AR
<How to operate>
1 Press POWER ON / OFF button.
2 Press MODE SELECT button to set operation mode to FAN.
NOTE : Temperature can not be set in FAN operation.
SL-1AR
SL-1.6AR
SL-2AR
<How to operate>
1 Press POWER ON / OFF button.
2 Press MODE SELECT button to set operation mode to AUTO.
3 Press SET TEMPERATURE button to set the desired temperature.
NOTE: The set temperature changes 1°C when the
press one time AUTO MODE 19 to 28°C.
"AUTO" works to change by itself the operation mode either to cooling or heating
according to the room temperature.
SLH-1AR
SLH-1.6AR
SLH-2AR
<Timer function>
It is convenient to set the timer when you go to bed, when you get home, when you
get up, etc.
h
1 Select the timer mode by pressing the
TOO TOO
COOL
• Each time this button is pressed, the the timer mode is changed in sequence:
(OFF TIMER)
FAN SELECT
1
2 Set the time of the timer using
TIME
2
• Each time this button is pressed, the set time increases by 1 hour to 12 hours.
RESET
To release the timer:
• Press the
displayed.
Note:
The OFF TIMER and the ON TIMER cannot be set at the time.
(ON TIMER)
TIME
SELECT
button unit (OFF TIMER) and
54
or
SELECT
button during operation
TIMER RELEASE
the button.
(ON TIMER) are not
button is