Section 6: Service; Troubleshooting - Grizzly Slip Roll 16 Gauge G5771 Owner's Manual

SEctION 6: SERvIcE

review the troubleshooting and procedures in this section to fix or adjust your machine if a problem devel-
ops. if you need replacement parts or you are unsure of your repair skills, then feel free to call our technical
support at (570) 546-9663.
Operations
symptom possible Cause
slip roll creates 1. rollers are not parallel.
cones when trying
to create cylinders.
a noticeable crease 1. excessive pressure applied in one spot.
is formed in the
workpiece.
Crank does not turn 1. gearbox end of upper roller is not secure.
upper and lower
rollers.
2. gears are damaged.
slip roll does not 1. Machine capacities exceeded.
bend material.
2. rear roller not engaged.
-24-

troubleshooting

possible solution
1. adjust rear roller adjustment knobs as necessary to
be sure the rear roller and upper roller are parallel.
1. reduce the radius and perform the bend in several
passes.
1. re-center the bushing and secure the hex bolt and
jam nut (Step 5 on Page 20).
2. Check/replace gears.
1. use materials within the capacity of the slip roll.
2. Check/adjust rear roller.
g5771 50" slip roll 16 gauge