AEG DGK6681HM User Manual page 38

38 www.aeg.com
It is recommended to leave
the hood operating for
approximately 15 minutes
after cooking.
The control Panel is a
sensor field. To operate the
hood touch the symbol
exactly in the middle for at
least 1 second.
To operate the hood:
1. Open the glass with control panel
symbols.
2. Touch the
appliance.
3. If needed, change the speed by
touching the desired symbol.
To turn off the appliance touch
again.
3.2 Timer
This function allows to turn off the
appliance after 5 minutes of operating.
The function can be used only if the
appliance operates on first 3 motor
speeds.
1. Touch the
Timer starts to flash.
2. After 5 minutes the appliance turns
off.
To turn off the function touch
While heating up food, cooking with covered pots.
While cooking with covered pots on multiple cooking zones or burners, gentle
frying.
While boiling and frying big quantities of food without a lid, cooking on multi‐
ple cooking zones or burners.
While boiling and frying big quantities of food without a lid, big humidity.
to switch on the
symbol.
3.3 Hob²Hood function
It is an automatic function which
connects the hob with a hood. Both the
hob and the hood have an infrared signal
communicator. Speed of the fan is
defined automatically on basis of mode
setting and temperature of the hottest
cookware on the hob. You can also
operate the fan using the hob manually.
The function can be activated from panel
of the hob.
Led lamp switches on when the
connection is established between the
hob and hood.
3.4 Filter notification
Filter alarm reminds to change or clean
the charcoal filter and clean the grease
filter.
• After 40 hours of usage, the symbol
turns on for 30 seconds. The
grease filter must be cleaned.
again.
The element underneath the
hood (1) is a signal receiver
of the function.
For more information how to
use the function refer to the
hob user manual.