Advertisement
Pressure Drop Data
This pressure drop testing was conducted in accordance with AMCA Standard 500-D using the three configurations shown. All
data has been corrected to represent standard air at a density of .075 lb/ft
Actual pressure drop found in any HVAC system is a combination of many factors. This pressure drop information along with
an analysis of other system influences should be used to estimate actual pressure losses for a damper installed in a given
HVAC system.
AMCA Test Figures
Figure 5.3 Illustrates a fully ducted damper. This
configuration has the lowest pressure drop of the
three test configurations because entrance and
exit losses are minimized by straight duct runs
upstream and downstream of the damper.
Figure 5.2 Illustrates a ducted damper
exhausting air into an open area. This
configuration has a lower pressure drop than
Figure 5.5 because entrance losses are minimized
by a straight duct run upstream of the damper.
Figure 5.5 Illustrates a plenum mounted damper.
This configuration has the highest pressure drop
because of extremely high entrance and exit
losses due to the sudden changes of area in the
system.
Damper Size
12 in. x 12 in.
5.5
5.2
5.3
3
(1.201 kg/m
5D
Figure 5.3
5D
Figure 5.2
Figure 5.5
Damper Size
24 in. x 24 in.
5.5
5.2
5.3
SMD-401
3
).
6D
4 (W) (H)
D
3.14
Damper Size
36 in. x 36 in.
5.5
5.2
5.3
Advertisement
