Invacare TDX Series Owner's Manual page 41

All manuals and user guides at all-guides.com
FRONT RIGGINGS
FIGURE 8 - INSTALLING/ADJUSTING
ADJUSTABLE ANGLE FLIP-UP FOOTPLATES
ADJUSTABLE ANGLE FLIP-UP FOOTPLATE ANGLE ADJUSTMENT
(FIGURES 8 AND 9)
1. Loosen, but do not remove the
two (2) flat screws, washer and
locknuts that secure the
footplate to the footplate hinge.
2. Position the articulating
footplate to the necessary angle
to accommodate the user.
3. Retighten the two (2) flat
screws, washers and locknuts.
ADJUSTABLE ANGLE FLIP-UP FOOTPLATE PERPENDICULAR AND/
OR INVERSION/EVERSION ADJUSTMENT (FIGURES 8 AND 10)
NOTE: It is not necessary to remove the footplate to perform this adjustment.
1. Insert a flathead screwdriver
through the half clamp on the
articulating footplate.
2. Slowly turn nylon adjustment
screw in or out until articulat-
ing footplate is perpendicular to
the footrest assembly or the
desired inversion or eversion is
obtained.
Part No. 1114809
o
90 Footrest Support
Flat Screws
Articulating
Footplate
Half
Clamp
Washers
Half Clamp
Locknuts
Footrest Support
Articulating Footplate
FIGURE 9 - ADJUSTABLE ANGLE FLIP-
UP FOOTPLATE ANGLE ADJUSTMENT
FIGURE 10 - ADJUSTABLE ANGLE FLIP-
UP FOOTPLATE PERPENDICULAR AND/
41
Footplate Hinge
Nylon
Adjustment
Screw
Footplate Hinge
Footrest Support
Footplate
OR INVERSION/EVERSION
ADJUSTMENT
TDX WHEELCHAIRS
SECTION 4
Side View Of
Footplate
and Footrest
Support.
Front View Of
Footplate and
Footrest Sup-
port