Summary of Contents for RoboVent PRC Series
- Page 1 PRC Series Portable Room Cleaner Owner’s Manual Installation, Operation & Maintenance Revised 04-30-2020...
- Page 3 PRC Series Models: PRC-1200 Portable Room Cleaner 1200 CFM PRC-800 Owner’s Manual 800 CFM Installation, Operation & Maintenance Manufactured by: RoboVent 37900 Mound Road Sterling Heights, MI 48310 USA (888) 762-6836 www.robovent.com ©2020 RoboVent Product Group, Inc. All rights reserved.
- Page 4 Features of the PRC Series ..... .Section 200 ... . .
- Page 5 Use extreme care to make sure you are never in a position where your body (or any item you are in contact with, such as a screwdriver or test instrument) can accidentally touch the blower wheel. ROBOVENT • PRC SERIES OWNER’S MANUAL...
- Page 6 High Density Foam Barriers and Built-In Acoustical Bass Traps have been engineered into the RoboVent PRC design to make it one of the quietest portables in today’ s market. The RoboVent PRC's quiet 70 dBA FIGURE 2 sound rating will not add to your shop's ambient noise level.
- Page 7 SECTION 200 Features of the PRC Series 8. Carbon Pre-Filter Your RoboVent PRC is equipped with a MERV 8 Carbon Pre-Filter that will remove larger contaminants and odors, and help extend the life of your primary Cartridge Filter. Figure 3.
- Page 8 Compare the number of items received against the carrier’s bill of lading. Inspect all items for apparent damage. Immediately report any shortages or obvious damage to the carrier and to your local RoboVent Representative, call the factory at 1-(888)-762-6836, or email: customer.service@robovent.com.
- Page 9 SECTION 400 Installation/Operation Electrical Hook-Up The RoboVent PRC comes ready to plug into a 20 amp, 110 volt service. Figure 4. (If ordered as a 480 volt, 3-Phase model the connection must be made by a licensed electrician and in accordance with NEC and all applicable local codes.) Amperage requirements of the...
- Page 10 General Operation in Section 400. The cartridge can also be taken out and manually cleaned with compressed air. If the RoboVent PRC still does not draw sufficiently, then replace the cartridge. PRC-1200:...
- Page 11 SECTION 600 Troubleshooting RoboVent PRC is making excessive noise. Check the following: 1. Make sure the blower wheel is not hitting the venturi. 2. Check that all motor bolts are securely tightened. 3. Make sure motor bearings are good. (Amperage rating will be higher than normal.)
- Page 12 Improving Lives through Clean Air ™ 37900 Mound Road, Sterling Heights, MI 48310 USA ROBOVENT.COM • 888.ROBOVENT ©2020 RoboVent...
Need help?
Do you have a question about the PRC Series and is the answer not in the manual?
Questions and answers