SINO SinoV-AP-W500 Quick Install Manual

IEEE 802.11n 150Mbps In Wall Access Point
SinoV-AP-W500 Quick Install Guide
The Access Point is properly
rooms,hospital,school and villa as it could keep previous face of
wall and need not any position to place the device.You only
unscrew old panel of wall box and connect the RJ45 connector to
the AP WAN port and insert the AP to wall box and screw it then
cover the face panel.It decrease the OPEX and Plug and Play.
Hardware installation
Step1 screw the metal bracket in the access point then adjust the
bracket position suitable of wall box.
Step2 fasten tightly into the Bottom Faceplate until it's flushed into
the wall.
Step 3 cover the top faceplate on the bottom faceplate.
For rooms of hotel,hospital or school
You have to connect the access point of each room to IEEE 802.3af switch by using the UTP-5 cable.The
network block diagram as the following:
installed in hotel
16/24-ports PoE Dump Switch
SinoV-PSE-16-M-AF
laptop
Router/gateway
802.3af PoE Switch
In Wall Access Point
Ethernet UTP-5 cable
SinoV-AP-W500
WiFi
iPhone/
iPad/tablet
smart phone
Room#1001
Internet
In Wall Access Point
SinoV-AP-W500
WiFi
laptop
iPad/tablet
smart phone
Room#1009
http://www.sinovoip.com.cn
iPhone/