Page 6
Table-installation-Flat view Position: 110cm Installation guidance: Stick the rubber foot on the bottom of device and support respectively, assemble the device Fastening method 1 connect the power interface on the device Put the device on suitable place, and connect the other side of power cable with the power adaptor and then power it on...
Page 7
Table-installation-Elevation view Position: 70cm Installation guidance: Stick the rubber foot on 2 sides of the support back respectively, assemble the device with Fastening method 1 connect the power interface on the device Screen connect the other side of power cable with the power adaptor and then power it on...
Page 8
Wall-mounting-Flat view (cables upwards) Position: Installation guidance: Wall-mounting card Drill here Drill here 150cm mentioned content in this manual and realistic installation method. put plastic expansion pipes into the holes Screen Drill the plastic holes on support, thread the embed it into the slot Connect the cable with power interface on device, assemble the device with support Fastening method...
Page 9
Wall-mounting-Flat view (cables downwards) Position: Installation guidance: Wall-mounting card 150cm Drill here Drill here mentioned content in this manual and realistic installation method. put plastic expansion pipes into the holes Drill the plastic holes on support, thread the Screen embed it into the slot Connect the cable with power interface on device, assemble the device with support Fastening method...
Page 10
Wall-mounting-Top view (cables upwards) Position: Installation guidance: Wall-mounting card 180cm Drill here Drill here mentioned content in this manual and realistic installation method. put plastic expansion pipes into the holes Drill the plastic holes on support, thread the embed it into the slot Screen Connect the cable with power interface on device, assemble the device with support...
Page 11
Wall-mounting-Elevation view (cables downwards) Position: Installation guidance: Wall-mounting card Drill here Drill here mentioned content in this manual and realistic installation method. 100cm put plastic expansion pipes into the holes Drill the plastic holes on support, thread the Screen embed it into the slot Connect the cable with power interface on device, assemble the device with support Fastening method...
Page 12
Instructions Reset the Device 1. With the device power-on, press RESET for 5s and release on display screen and enter the state of to be activated RESET irreversible, please operate with care Other Matters (output DC 5V/2A)
Warranty Warranty Service the device problems found are not resulted by hardware or software system extra fee incurred by the onsite service. Warranty Period Warranty Scope warranty scope: • Malfunction caused by force majeure such as natural disasters and external...
Page 15
Brand Name: Model No.: OS-K21-11901 Universal Ubiquitous Co.,Ltd. E-mail: wangjianhao@uni-ubi.com hereby declares that this [Name: Face recognition terminal, OS-K21-11901] is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. Adapter shall be installed near the equipment and shall be easily accessible.
Page 16
F F CC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.