Advertisement
MASTER SECTION
1. SEND/EFFECT
Adjust the strength of after-effect signal
2. HEADPHONE LEVEL
When the SOLO button next to it was
pressed, this knob can be used to
adjust the volume of signal sent to
headphone for sound monitoring
3. EFFECT DISPLAY
LCD display for 16 effects
4. EFFECT SELECTION
Turn the knob to select different effects
and press the knob to confirm selection
5. EFFECT LEVEL
Adjust the volume of effect signal
6. STEREO GRAPHIC EQUALIZER
Equalizer provided for tone control and
precise high quality sound over each
frequency
7. OUTPUT MAIN FADER (LEFT/RIGHT)
Master fader for adjustment of left/right
output volume
8. MP3 LEVEL
Adjust the volume of MP3/Bluetooth signal input
9. PHANTOM POWER SELECTION
Press this button when the phantom power supply
is switched on. The phantom power supply is necessary
for condenser microphones and is activated when using
the Mic/Line input jack.
10. PHONE OUTPUT
Connect headphone to this jack to monitor output sound.
If SOLO button is pressed, you can monitor pre-fader sound
before output.
3
1
2
6
5
8
4
9
10
7
Advertisement
