Advertisement

1. Unpacking

Check that all these accessories are present:
1 power supply cable
1 straight Ethernet cable (letter A on the cable)
1 USB-serial adapter cable
1 box including : 1 Audemat CD with the product documentation, 1 Quick Start notice, 1 Quality Control
form

2. Network configuration using the console

Before connecting your encoder to the broadcast chain, check network parameters and modify them if needed.
Connect a PC to the COM0 serial port on the front panel of the encoder and the power supply cable to the rear
panel.
Connect the encoder to the mains and start it.
On your PC, open a terminal session (with Hyperterminal, Tera Term...).
If you don 't know which COM port to select for your terminal session:
Press the Windows and Pause keys at the same time and select Hardware or System and Device manager (depending on the
Windows version).
Click on "Ports (COM & LPT)" to list physical and virtual COM ports installed on the PC and select "USB-to-serial" to view the
COM port used for your connection to the encoder. This is the port you will need to select for your terminal session.
Enter the following parameters: 9600 bits per second, 8 data bits, no parity, 1 stop bit, no flow control.
Once connected to your encoder, enter the command:
IP?
Press the <Enter> key and the encoder sends the current IP address, for instance:
192.168.0.1
To set a new IP address, enter the command and press the <Enter> key:
IP=x.x.x.x
Where x.x.x.x is the new IP address.
You might in the same way check and reset the network mask (press the <Enter> key after each command):
MASK?
MASK=x.x.x.x
the gateway:
GATEWAY?
GATEWAY=x.x.x.x
You will then need to restart the encoder to apply the new network parameters:
RESET
1/4
fMb50 / fMb80
Quick Start

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FMB50 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Worldcast Systems FMB50

  • Page 1 / fMb80 Quick Start 1. Unpacking Check that all these accessories are present: • 1 power supply cable • 1 straight Ethernet cable (letter A on the cable) • 1 USB-serial adapter cable • 1 box including : 1 Audemat CD with the product documentation, 1 Quick Start notice, 1 Quality Control form 2.
  • Page 2 English version - 03/2011 3. Connecting to the embedded Web site Connect the Ethernet cable between the RJ45 and the network.. 2. Open a Web browser (Internet Explorer, Mozilla…) and enter the encoder IP address you just set in the previous previous step.
  • Page 3 English version - 03/2011 6. Configuring the radiotext using the embedded Web site 1. On the embedded web site home page, click “Radiotext parameters”: 2. Set the default radiotext (64 characters max) and click “Set”. Default settings: • Number of repetitions = 1 •...
  • Page 4 English version - 03/2011 8. Setting you encoder for a connection to the automation software using the embedded Web site The automation software generally sends an ASCII string with titles of songs, artist information, program information... The commands sent by the automation software have to be defined in the encoder to be properly understood. 1.

This manual is also suitable for:

Fmb80

Table of Contents