Frisco 245954 Quick Start Manual

NO-SHOCK DOG BARK COLLAR
Make sure to read this guide carefully and review the warnings and battery-handling instructions
in the full instruction manual prior to setting up and using the product.

How the Collar Works

This collar has seven sensitivity levels and uses sound and vibration to deter barking. As your dog
barks, the collar progressively cycles through combinations of sound and vibration until your dog's
eighth bark, when the collar enters a 1-minute sleep period for your dog's safety. Make sure you start
at the lowest sensitivity level (1) and work your way up as needed.
DO NOT PUT THE COLLAR ON YOUR DOG WITHOUT TESTING THE COLLAR FIRST.

Components

Collar Features

Vibration
Probes
Collar
Sensitivity
Battery
Adjusters

Installing the Battery

1. Remove the blue faceplate from the collar.
Probes
2. Pull the collar loose to expose the battery cover.
3. Remove the cover, insert the battery and replace the cover.
4. Pull the collar tight and replace the faceplate. It should click into place.
Test Bulb Tool
Faceplate
Once the battery is installed, you should hear a beep, and the
collar will be set to the fourth sensitivity level.
Microphone
Sensor
Sensitivity
Indicator Light
Adjusters
Insert Battery
Battery Battery Cover

Changing the Probes

The collar comes with short probes pre-installed. These work best for short-haired dogs.
If you have a long-haired dog, you should change the probes to the longer probes.
Use the test bulb tool to loosen and tighten the probes. It fits over the probes like a wrench.
For short-hair dogs, use the short probes.

Testing the Collar

Locate the sound hole between the probes. This is where the collar listens for your dog's barks.
1. Hold the collar with the probes facing you.
3. Repeat 3 more times.
You should hear a beep, see the light and feel a moderate vibration.

Adjusting the Sensitivity

The collar comes pre-set to the fourth sensitivity level. Adjust it using the + and – buttons
on the side of the collar. Listen for a beep while you adjust the level. If you don't hear it,
you're at the highest or lowest level.
For long-hair dogs, use the long probes.
2. Blow a small puff of air at the hole.
You should hear a beep and see
the indicator light.