Advertisement
J-MAX™ ANTENNA MOUNT
1
Contents:
A
C D
E
2
Install Base to Mounting Surface
Use the provided lag screws or other
fasteners appropriate for the surface
material.
3
Install Pivot Bolt Through Top Hole in Base and Pole
Pole can be installed in either orientation.
Align the square portion of bolts with the
holes and insert fully.
Do not tighten pivot bolt nut until final pole
position is determined.
© Copyright, Proxicast LLC. All rights reserved.
Contents may vary depending on model - Specifications subject to change without notice.
ASSEMBLY INSTRUCTIONS
F
G
B
Tools required: M10 & M13 Wrenches
www.proxicast.com
A. Base
B. Pole
C. M6 Pivot Bolt
D. M6 Long Lock Bolt
E. M6 Short Adjustment Bolt (x2)
F. M6 Serrated Flange Nut (x4)
G. M8 Lag Screw (x4)
Rev 20211129
Advertisement
Table of Contents
Related Manuals for Proxicast J-MAX
Summary of Contents for Proxicast J-MAX
- Page 1 Align the square portion of bolts with the holes and insert fully. Do not tighten pivot bolt nut until final pole position is determined. © Copyright, Proxicast LLC. All rights reserved. Rev 20211129 Contents may vary depending on model - Specifications subject to change without notice. www.proxicast.com...
- Page 2 Tighten All Nuts Prior to installing antennas or other devices on the pole, check all bolts and tighten all nuts. © Copyright, Proxicast LLC. All rights reserved. Rev 20211129 Contents may vary depending on model - Specifications subject to change without notice.
Need help?
Do you have a question about the J-MAX and is the answer not in the manual?
Questions and answers