Summary of Contents for ACCO Brands GBC Sharp SmartPunch Pro
- Page 1 Sharp SmartPunch ™ Installation Manual ACCO Brands, Inc. Four Corporate Drive Lake Zurich, IL 60047 www.acco.com Sharp SmartPunch Pro Installation Manual...
-
Page 2: Table Of Contents
Contents Page Recommendations and Pre-requisites Unpacking Cable Connections Installing the Sound Deadening Foam Docking Bracket Installation Leveling & Height Adjustment Final Steps Sharp SmartPunch Pro Installation Manual... -
Page 3: Recommendations And Pre-Requisites
1 Recommendations and Pre-requisites • You will need the installation kit provided with the SmartPunch Pro unit, which can be found in the main carton. 2 Unpacking • Inspect the outside of the package for shipping damage. If there is evidence of shipping damage, contact the shipping carrier immediately. -
Page 4: Cable Connections
3 Cable Connections and Paper guides Review the table below to identify which section of the guide to refer to install the SmartPunch Pro Section Device upstream to SmartPunch Pro MX-CF11 Inserter (or) MX-ST10 High Capacity Stacker MX-RB18 Curl correction unit Cable connections a) i) Remove the finisher rear cover and plug the 7 pin communication cable to CN145 on the finisher board. - Page 5 a)iii) Plug the free end of the cable from step a) into the right side of the SmartPunch Pro. b) Plug the appropriate power cord into the side of the machine next to the communication connector. The exact location can be seen in the above picture. Insert the plug into the power supply socket.
- Page 6 Go to Section 4 to complete the installation. Cable connections Follow the same steps as in 3.1 a, b. c) There are two entrance paper guides provided with the SmartPunch Pro. Use the shorter paper guide measuring about 24mm (in paper flow direction) when used in conjunction with Curl correction unit MX-RB18.
-
Page 7: Installing The Sound Deadening Foam
4. Installing the Sound Deadening Foam Supplied with the SmartPunch Pro, you will find six strips of sound deadening foam that are shipped loose for field installation. These are not attached at the factory to avoid compression and/or damage during shipping. To install, simply peal the back off to reveal the adhesive using the following steps as a reference. - Page 8 Apply another longer strip to the side cover. Align it so that the long edge of the foam is in line with the end of the horizontal foam. Exit side complete 4.2 Paper Entrance Side (Main Unit Side) Apply the remaining short strip to the Top cover. Align it so that a.
-
Page 9: Docking Bracket Installation
5. Docking Bracket Installation The docking brackets are shipped in a separate bag along with size M4x10 mounting screws (not shown). MX-ST10 High Capacity Stacker Install as shown with the bracket marked “R” on the right side facing you as you look at the exit side of the upstream device (pictures shown). -
Page 10: Leveling & Height Adjustment
6. Leveling & Height Adjustment 6.1 Height Setting No height adjustment of the SmartPunch Pro is required, for an installation site with a level floor. If the floor is uneven then it is recommended to set the level of the SmartPunch Pro using the upstream device as a reference. -
Page 11: Final Steps
7. Final Steps 7.1 Main Unit & Finisher Firmware Confirm that the main unit and finisher have the latest firmware installed. Firmware can be obtained by contacting Sharp service. 7.2 Setting the Dip Switch SmartPunch Pro unit is fitted with a dip-switch and the setting should be changed depending on the main unit it is attached to.