Advertisement
a
STAGE 3
To commence system installation press and hold the button for 5 seconds
until button starts flashing red. This means the ZigBee network is ready to
accept RF OMNIE Home devices.
STAGE 4
When everything is paired press and hold button for 5 seconds or till the
flashing stops. If you want to replace or add RF OMNIE Home devices
please ensure you follow steps 3 to 4.
CHECKING SYSTEM CONFIGURATION
To check which devices of the RF Home system are paired and have been
configured correctly, you can use Identify mode. Press the button to
activate Identify mode. Using Identify mode the USB Coordinator will show
all equipment that is connected to your system. Press the button again to
cancel Identify process. Identify mode will time out after 10 minutes.
Page 3/4
Last Updated: 7th May 2020
© 2017 - OMNIE. No. 6446222 | VAT No. 941838600 | Address: Trade City, Sidmouth Road, Exeter, EX2
5GL, United Kingdom. Call us on 01392 36 36 05. Email projects@omnie.co.uk.
OMNIE HOME USB COORDINATOR
IG OHC 05
Advertisement
