Advertisement

Quick Links

Basketball Scoreboard
Operating Instructions
Proto Electronics Ltd │ 382 Montreal Street PO Box 7577
Christchurch │ Ph 03 365 3366
www.proto.co.nz│ enquiries@proto.co.nz

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the P10 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Proto P10

  • Page 1 Basketball Scoreboard Operating Instructions Proto Electronics Ltd │ 382 Montreal Street PO Box 7577 Christchurch │ Ph 03 365 3366 www.proto.co.nz│ enquiries@proto.co.nz...
  • Page 2 Introduction The Proto Electronics Basketball Scoreboard and shot-clocks, when used with the Player Fouls side displays, is designed to meet the requirements of FIBA 2. It can also be supplied and used without the Player Fouls displays. Control is via hard wired bench controllers.
  • Page 3 By default, when switched on, the scoreboard will start in media mode and stream any images stored in memory of the scoreboard. Press RESET once to enter game mode. Now you should see scoreboard display information on both the controller display and the scoreboard. To go back to media mode press MEDIA/CLOCK once to enter clock mode, then press MEDIA/CLOCK again to enter media mode.
  • Page 4 Single press PERIOD to reset the game time to the period/interval it is currently in Double press PERIOD to cycle through the game periods. Period 1 Interval 1 Period 2 Interval 2 Period 3 Interval 3 Period 4 Interval 4 Extra time Extra Interval During a game double press CLEAR TIME OUTS to clear the times...
  • Page 5 3. Set Quarter Interval Time Use the red +1 & -1 buttons to increase and decrease the minutes, & the • green +1 & -1 buttons to increase and decrease the seconds. Press EDIT once done to move to the next item to edit or RESET to exit •...
  • Page 6 When the name you want is displayed press ENTER again • Now you can type another preset number and edit that if you want or • press RESET to exit the edit menu Configuring the Media Control The scoreboard needs to be connected to a PC directly via a gigabit Ethernet link. The PC requires the relevant LED control software to be installed.

Table of Contents