Operating Instructions - GE AHTT06 Owner's Manual & Installation Instructions

Controls
Features and appearance will vary.
Lights beside the touch pads on the air conditioner control panel
indicate the selected settings.
7
1
Air Conditioner Controls
1. Power Pad
Turns air conditioner on and off. When turned on,
the display will show the set temperature and user
settings.
2. Display
Shows the room temperature or time remaining on the
Delay timer. Shows the Set temperature while setting
the temperature in Cool, Dry or Eco modes.
3. Temp and Delay + /– Pads
can be set in Cool, Dry and Eco mode.
4. Mode Pad
or Eco mode.
5. Fan Speed Pad
In Cool, Eco or Dry
to Auto, Quiet, Med, or High on the unit.
In Fan
or Quiet on the unit.
6. Delay (set by remote control only)
With the Delay On feature the unit will operate in ECO
mode at the set temperature and fan speed.
After pressing Delay pad the display will show "- -".
Pressing the Delay + button will increase the hours
by 1 from 24. The Delay – button will decrease the
hours by 1 from 24 to 1. When the set delay time has
expired, the unit will turn on as if the POWER button
was pressed.
To cancel the Delay function, press the POWER
button.
7. Sleep Pad
The SLEEP mode sets the unit to gradually change
settings over an 8 hour period to allow for some
increased energy efficiency during sleep hours.
The SLEEP mode is available only in COOL, DRY and
ECO mode.
Press the SLEEP mode pad and its light will illuminate.
In SLEEP mode, the unit will automatically change and
display the fan speed depending on the prior settings.
49-5000634 Rev. 1
3
5
2
Fan Only, Cool, Dry
High, Med,
Remote Control
8
4
If fan speed was High or Med, the unit will decrease
the fan speed by one setting.
If fan speed was Quiet or Auto, the unit will set the fan
speed as Quiet.
The fan will stay the set speed setting for 8 hours from
the time the SLEEP mode button was pressed. The
air conditioner will then raise the set point by 2°F after
1 hour and 2°F more after another hour where it will
remain for the next 6 hours. The display will not show
the adjusted set points. During this time, the display
will show "08" at the beginning, representing the 8 hour
run time, and will decrease by 1 with each passing
hour. After 8 hours, the air conditioner will resume the
settings that were in place before the SLEEP mode
button was pressed.
While in SLEEP mode, pressing the SLEEP or
POWER button will exit SLEEP mode. The only other
allowable button in sleep mode is SPEED. Any other
button will result in a double beep, confirming an invalid
operation.
8. Filter Reset Pad
This feature automatically notifies you that the filters
must be cleaned. The indicator light will come on after
250 hours of operation. Clean the filters (REFER TO
PAGE 7), place them back into the unit, and press the
Filter Reset pad. The light will go off.
9. WiFi Connect Pad
Enables connection of the air conditioner to the home
WiFi. Download App for details at:
www.GEAppliances.com/connect.
10. Quiet Mode
Sets fan speed to QUIET
ECO, and DRY modes. Can be set on the unit or by
remote control.
1 Power
5
Speed
4
Mode
10
Quiet Delay
9
COOL, FAN,
3
6
5