Daktronics FLR3-100 Installation Quick Manual

FLR3-100 Installation Quick Guide
This quick guide provides steps for installing the receiver and setting up a FLR3-100 key fob with a
Fuelight Gen 3 display.
TM

Installing the Receiver

1. Using a flat-head screwdriver, open the digit face to access inside
the digit cabinet.
2. Remove both antenna hole plugs from the digit face. Refer to
Figure 1.
3. Place the receiver on to the mounting studs on the back of the
digit face. Refer to Figure 2.
4. Use a / " nut driver to secure the receiver to the mounting studs
5
16
using the two provided nuts.
5. Place the threaded end of the antenna cable through the
antenna hole.
6. Place the flat washer over the threaded end of the antenna cable. Refer
to Figure 2.
7. Thread the provided nut on to the threaded end of the antenna cable
and tighten using an
8. Thread the female end of the antenna on to the threaded end of the
antenna cable and turn the antenna clockwise until snug. Refer to
Figure 2.
9. Connect the receiver cable from receiver to the driver. Refer to Figure 3.
10. Neatly secure any excess cable with cable ties.
11. Close and secure the digit face.
Antenna Cable
Figure 3: Final Receiver Assembly

Setting the Security DIP Switches

The FLR3-100 key fob has a series of dip switches on the back to give it a unique address setting. Set
these switches to a unique setting to prevent others from being able to control your display.
1. Remove the small cover on the back of the FLR3-100 key fob radio. Refer to Figure 4.
2. Using a paper clip or a micro screwdriver, set the switches to a unique setting.
Note: Do not change switches nine and zero.
3. Replace the back cover.
13 June 2017
DD2291475
Rev 06
/ " wrench.
11
32
Receiver
201 Daktronics Drive Brookings, SD 57006
www.daktronics.com/support
800.325.8766
Figure 1: Digit Door Receiver
Mounting Overview
Driver
Digit Cabinet
Page 1 of 4
Mounting Stud
Antenna Hole Plug
Digit Face
Receiver
Mounting Stud
Nut
Antenna
Washer
Nut
Figure 2: Mounting Profile