ESL 3BS Installation Manual

ESL 3BS WALL SWITCH
Switch Installation Guide – ESL-KNX-3BS-01WH
Switch Setup
Learn In the Switch
Press and hold the pairing/reset button for 2 seconds. The indicator lights will begin to flash, showing that it is waiting to be paired
with the app. Communication will remain open for 1 minute.
Open the ESL Network Lighting App.
Select the DEVICES button from
the dashboard.
When the switch is communicating with the app, the indicator lights will flash rapidly and then turn solid once complete. The
switch is now learned into the app and is ready to be assigned to a group. Please note that the switch MUST be added to a group
of fixtures in order for it to operate.
For more information about how to install and operate the ESL Networking App please refer to the Konex User Guide.
The ESL 3BS Wall Switch connects to the Konex
Control System with the ESL Network Lighting App and
must be added to a group of fixtures for basic on/o ,
dimming and kelvin control.
Select LEARN NEW DEVICE and
then ADD WITH BLUETOOTH.
To reset the switch, press and hold the Pairing/Reset button for 10
seconds until the communication lights begin to flash. *If it has
previously been paired, it needs to be deleted from the app manually.
PROOF
Dim/Kelvin Up
Dim/Kelvin Down
On/O
Add the switch by selecting the
plus (+) next to it.
Copyright © 2020 ESL Vision, LLC. All rights reserved. Rev: 10/27/2020
PAGE 1 OF 2
Indicator
Lights
Pairing/Reset
Panel(x1)