Page 1
Wet and Dry Shaver User Manual Model No.: MR-7200B Rev 2 Note: The specifications and/or components of this appliance are subject to change without prior notice.
1 Safety Instructions When using electrical appliances, basic safety precautions should always be followed, including the following: Carefully read this instruction manual before using the appliance and USB cable. • Keep the appliance, accessories and USB cable out of reach of young children. •...
Page 6
• The use of accessories not intended for use with this Appliance may cause injuries to the user or damage to the Appliance, components and/or the USB cable. • Do not sit the Appliance on other appliances, on uneven surfaces or where it could be subject to heat sources (e.g., radiators or stoves), direct sunlight, excessive dust or mechanical vibrations.
Page 7
WARNING Only use the USB cable that was supplied with this Appliance. Consumers are cautioned against trying to replace the battery. Using and/or purchasing counterfeit and/or inferior quality batteries have the potential to cause fire, personal injury, and/or damage to property. These batteries are typically found on online-auction websites or from other retailers and are known to pose a potential safety risk.
2 Components Cleaning Brush LED Display Shaver Blade Cover On / Off – Speed Button Charging Plug Pop up Trimmer USB Plug / Cable Shaver Blades 3 Instructions for Use IMPORTANT: Refer to the Section “Lubrication” before first use. NOTE: This appliance and its accessories are rated IPX6 waterproof except for the USB cable.
Page 9
DO NOT allow to charge for more than 12 hours. Normal charge takes approximately 2 hours If any abnormality occurs during charging, (such as a burning smell or excessive heat or even a strange sound) immediately turn off the charger and disconnect the USB cable, then contact our service department for assistance.
4 Operation 4.1 Shaver NOTE: Remove the plastic Blade cover before use. • With the appliance fully charged, holding firmly in your hand, press the On / Off button to turn on. It will start in the default Low Speed. •...
4. Hold the shaver at right angles (90°) to your skin. 5. Stretch your skin and shave against the direction of your beard growth. NOTE: Applying excessive pressure does not provide a closer shave. 6. Switch OFF the shaver by pressing the on/off switch once or twice depending on the speed setting selected.
Position the trimmer over the hair to be trimmed and at the desired level, gently press the trimmer blade against your body part to be trimmed and gently slide across the skin. Note: Take care as the trimmer will remove hair very quick so be sure you only trim away what you want to trim.
5 Care and Cleaning 5.1 Cleaning To ensure optimal shaving and trimming efficiency, the shaver and trimmer must be cleaned regularly. IMPORTANT: Do Not use flammable liquids, chemicals, abrasive creams, steel wool or scouring pads for cleaning. DO NOT press on the top of the shaving blade surfaces as you will damage them.
• When clean, gently shake the excess water from the appliance. • Allow the appliance and Blade sections to sit and air dry naturally. • The trimmer can also be cleaned using running tap water and then allowed to air dry naturally. NOTE: Cleaning and user maintenance shall not be made by children without supervision 5.2 Lubrication...
8 Warranty Against Defect 12 Month Warranty Thank you for your purchase from Kmart. Kmart Australia Ltd warrants your new product to be free from defects in materials and workmanship for the period stated above, from the date of purchase, provided that the product is used in accordance with accompanying recommendations or instructions where provided.
Need help?
Do you have a question about the MR-7200B and is the answer not in the manual?
Questions and answers