1. Manuals
  2. Brands
  3. GREISINGER electronic Manuals
  4. Data Loggers
  5. T-Logg 160
  6. Operating manual

GREISINGER electronic T-Logg 160 Operating Manual

Data logger for humidity temperature
Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
E39.0.31.6C-03
Data logger for
humidity
temperature
T-Logg 160
Operating Manual
as of version V1.0
GREISINGER
electronic GmbH

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the T-Logg 160 and is the answer not in the manual?

Questions and answers

Summary of Contents for GREISINGER electronic T-Logg 160

  • Page 1 E39.0.31.6C-03 Data logger for humidity temperature T-Logg 160 Operating Manual as of version V1.0 GREISINGER electronic GmbH...
  • Page 2 2 of 8 General The logger T-Logg 160 is designed as a cost-efficient solution for monitoring humidity and temperatures. It enables an individual programming of the recording time. The last 16,000 measuring values can be stored in the memory.
  • Page 3 E39.0.31.6C-03 Operating instruction T-Logg 160 page 3 of 8 Connection ■ Assignment of the input jack (front view to the pins): Interface [–] Not connected Interface [+] Advice regarding state of logger upon delivery: Upon its delivery the logger is in a kind of 'sleeping state': The display does not show anything, the power consumption is at its minimum.
  • Page 4 E39.0.31.6C-03 Operating instruction T-Logg 160 page 4 of 8 BATTERY • Changing display / Value: The battery of the T-Logg is getting discharged soon. Replace the battery briefly. Even so data logging is still active. • Constant display The Logger battery is empty now and data logging has been stopped.
  • Page 5 E39.0.31.6C-03 Operating instruction T-Logg 160 page 5 of 8 Battery replacement Notice: As soon as appears at display, the battery needs to be replaced. If battery voltage power decreases continuously, data logging will be stopped (compare with operating status ‘...
  • Page 6 E39.0.31.6C-03 Operating instruction T-Logg 160 page 6 of 8 7. Insert the new button cell (type CR 2032) with correct polarity in the socket (the positive pole is on the retaining bracket). 8. Induct the sensor connection into the hole of the probe tube and put the board into the housing.
  • Page 7 Ø 15 mm, made of polyamide, screw-type plastic protection cap for quick response, made of polycarbonate protection cap: IP40 EMC: The T-Logg 160 have been manufactured in accordance with the regulations concerning EMC (2004/108/EG). The device meets EN61326-1. Additional error: < 1%.
  • Page 8 E39.0.31.6C-03 Operating instruction T-Logg 160 page 8 of 8...

This manual is also suitable for:

T-logg 160-set

Table of Contents