Portable power station wth emergency jumpstart (16 pages)
Summary of Contents for Streetwize SWPP9
Page 1
Portable Power Station & Emergency Jumpstart (& Air Compressor - SWPP9 ONLY) Instruction Manual Model No’s. SWPP9 – WITH Air Compressor SWPP10 – WITHOUT Air Compressor IMPORTANT WARNING: This product is supplied with a minimal charge at manufacture, it is unable to function in any way unless the unit is fully charged immediately after purchase.
IMPORTANT SAFETY INSTRUCTIONS • This product is intended for domestic use only, in accordance with these instructions • Check the rating plate to ensure that the correct input voltage is being supplied to the product. • Always switch the product off and remove the plug from the wall socket when not in use and before cleaning or changing accessories.
Page 3
Figure 1. SWPP9 & SWPP10 Figure 2. SWPP9 (ONLY) Front view showing control panel with Air Compressor 1. 12 Volt output socket with overload protection 12. Pressure Gauge 2. Color-coded battery meter 13. Compressor switch 3. Heavy duty 400 AMP booster clamp (– ) 14.
USAGE INSTRUCTIONS The power booster is designed as a compact, durable and portable jump start system for vehicles and boats. This self-contained system will start most vehicles and boats without the need for a host vehicle or 230V AC power supply. This system can also be used as a safe, portable source of 12V DC electric power in remote location and emergencies.
Page 5
RECHARGING 1. For maximum battery life, your jump starter should be kept and stored fully charged at all times. Battery life maybe shortened if the jump starter is stored in a discharged state. The table below shows the relationship of the frequency of use between recharging and the expected number of charge/recharge cycles.
As soon as possible connect your power booster system to one of the supplied chargers. Compressor operation (SWPP9 ONLY): Air Compressor Caution, only run the air compressor for 10 mins at a time, allow a cooling period of at least 10 mins in between uses.
BATTERY REPLACEMENT Figure 3. shows a back view of your power booster with the cover and eight screws removed. To replace the battery follow these steps. 1. Unscrew and remove the eight cross-headed screws at the back of your power booster. 2.
Power Pack by a person responsible for their safety. Streetwize: Ashburton Road West, Trafford Park, Manchester M17 1RY For product support: support@streetwizeaccessories.com...
Need help?
Do you have a question about the SWPP9 and is the answer not in the manual?
Questions and answers