Do you have a question about the YUI and is the answer not in the manual?
Questions and answers
Summary of Contents for CPA YUI
Page 1
1 di 16 MAINTENANCE MANUAL SPA YUI HIDROMASSAGE TUB Read carefully and keep for future referencee www.cpa-piscine.it Ver 01 – 2021-07-09...
Page 2
C.P.A. srl thanks you for choosing our products and wishes you to enjoy them fully of the relaxing and invigorating action of our whirlpools. To install the YUI whirlpool tub, it is necessary to proceed by following the instructions given here www.cpa-piscine.it...
WARRANTY CONDITIONS INTRODUCTION • The efficiency and safety of the YUI hot tub are guaranteed only by proper installation in compliance with the regulations in force in the place of use. The following installation guide provides the information necessary for a correct preparation of the rooms and of the water and electrical connection systems.
The use of the cover or other safety devices such as barriers and alarms is recommended to prevent uncontrolled access to the SPA. Continuous supervision by a responsible adult cannot be replaced by any safety devices. www.cpa-piscine.it Ver 01 – 2021-07-09...
CONTROL SYSTEM Heating power ABSORPTION * MAx absorption Voltage Electric voltage 220 ~ 1 phase JETS Total hydro jets N° n° Hydro jets n° Total air jets N° n° * Maximum nominal absorption in operation www.cpa-piscine.it Ver 01 – 2021-07-09...
Damage resulting from direct and prolonged exposure to sunlight is not covered by the warranty. In the case of an installation in such conditions, provide a cover (fixed or mobile) to protect the SPA. www.cpa-piscine.it Ver 01 – 2021-07-09...
Create a base or floor in reinforced concrete that is flat and suitable for supporting the weight of the hot tub and its guests. Check the load capacity of the installation site for a weight of 300 kg / www.cpa-piscine.it Ver 01 – 2021-07-09...
It is recommended to make a hydraulic connection to the drainage network that allows easy drainage for wintering the SPA or for prolonged periods of non-use. WARNING It is mandatory to provide for the possibility of easy removal of the tub from the installation space. www.cpa-piscine.it Ver 01 – 2021-07-09...
Failure to install systems that ensure an adequate level of the quality of the loading water determines the discharge of any liability arising from the failure to install the latter. www.cpa-piscine.it Ver 01 – 2021-07-09...
Page 10
- load the water into the tub even from a tap located not near the tub. www.cpa-piscine.it Ver 01 – 2021-07-09...
Page 11
(essential if the water comes from the well) The images are purely indicative: model and type must be chosen by the plumber based on the characteristics of the water and the domestic system. www.cpa-piscine.it Ver 01 – 2021-07-09...
WARNING The installation of the SPA must be carried out in compliance with the safety standard CEI 64-8 / 7 and subsequent amendments. www.cpa-piscine.it Ver 01 – 2021-07-09...
5 minutes, stop the pump and drain the water, then add clean water and start the whirlpool for 3 minutes, stop the pump, drain the water and clean the bathtub with a soft cloth. www.cpa-piscine.it Ver 01 – 2021-07-09...
The cover should have its own storage place where it is not likely to be damaged and where it cannot cause dangers WARNING Always remove the cover from the tub during use; failure to comply with this standard can expose users to serious health risks. www.cpa-piscine.it Ver 01 – 2021-07-09...
* Failure to comply with the above will result in the systematic forfeiture of the conditions of the guarantee. CPA srl excludes any liability for failure to comply with the safety standards in force for the individual technical sectors affected by this document.
Need help?
Do you have a question about the YUI and is the answer not in the manual?
Questions and answers