Lamp Replacement; Lamp Replace Counter - Fisher PLC-SW20 Owner's Manual

APPENDIX
When the life of Projection Lamp of this projector draws to an end, LAMP REPLACEMENT indicator lights yellow. When a
projected image becomes dark or the color of an image becomes unnatural, replacement of Projection Lamp is required.
Follow these steps to replace the lamp assembly.
1 Turn off the projector and disconnect AC plug. Allow the
projector to cool for at least 45 minutes.
2 Remove a screw with a screwdriver to remove Lamp Cover.
3 Remove 2 screws with a screwdriver and pull out Lamp
Assembly by grasping Handle.
4 Replace Lamp Assembly with a new one and tighten 2 screws
back. Make sure that Lamp Assembly is set properly. Replace
Lamp Cover and tighten a screw.
5 Connect AC Power Cord to the projector and turn it on.
6 Reset Lamp Replace Counter (refer to the section "Lamp
Replace Counter" below).
38

LAMP REPLACEMENT