Advertisement
AF-155NR.AK9 - IB (English) - inside page
Installing the Batteries
1. Using a Phillips screwdriver, open the battery compartment
door located on the back of the unit.
2. Insert 3 new AA (R6) batteries in the battery compartment.
Make sure batteries match the + and – as indicated in
the battery compartment diagram.
3. Replace battery compartment door. Do not overtighten screw.
Battery Installation
AA
AA
AA
Battery Use Cautions and Tips for Safety & Best Performance
• Only use the recommended/supplied batteries or equivalent.
• Use alkaline batteries for longer life.
• Do not mix old and new batteries, and do not mix alkaline, carbon-zinc or
rechargeable nickel-cadmium batteries.
• Insert batteries with proper polarity (+/–) as indicated.
• Remove exhausted batteries from product.
• Recharge rechargeable batteries under adult supervision.
• Do not attempt to recharge non-rechargeable batteries.
• Do not open batteries or heat them beyond normal ambient temperatures.
• To prevent battery leakage or damage remove batteries from a product if
it will not be used for a month or longer.
• Use extreme caution handling leaking batteries (avoid direct contact with
eyes and skin). If battery leakage comes in contact with eyes,
IMMEDIATELY flush the eye with lukewarm and gently flowing water for at
least 30 minutes. If skin contact occurs, wash skin with clear water for at
least 15 minutes. Seek medical attention if any symptoms occur.
• Store in cool, dry, ventilated area away from hazardous or combustible
material.
• Do not dispose of batteries in the household trash or fire.
• Follow applicable laws and local regulations for the disposal and
transportation of batteries.
Volume Switch
This unit comes equipped with a Volume Switch that is set to
Demo mode for in-store demonstrations. When you are ready
to play, slide the switch to High or Low.
FRONT VIEW
Press to take
a Pit Stop!
Press to slam
on the brakes!
Press to hear from
the Pit Crew!
Press to
hear speech & SFX
Volume
Switch
DEMO / HI / LOW
BACK VIEW
Light-Up Display
Press for Max
Horsepower!
Press on
the gas to
rev up and go!
Power
ON/OFF
Reset
Button
RESET
Free Play Mode
In Free Play Mode, you can press any button or turn the wheel
to activate sound effects, feel the wheel vibrate, and see the
LEDs light up on the display!
Challenge Mode
1. Press the Power ON/OFF Button and watch the Light-Up
Display call out driving directions! When an icon lights up
on the display, press the corresponding button on the steering
wheel to complete your challenge. For example, when the
Max Horsepower icon lights up on the display, press the
Max Horsepower Button to boost your speed!
2. Each time you complete a challenge, the steering wheel will
vibrate and the display will light up. If you fail a challenge,
a new challege will automatically follow. Once you complete
three challenges in a row, you win!
FCC Information
This device complies with Part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
WARNING: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void
the user's authority to operate the equipment.
CAN ICES-3 (B)/NMB-3(B)
Advertisement
