GET RX1 PRO Manual page 6

C. RX1 PRO INSTALLATION
REMEMBER TO WORK UNDER SAFETY CONDITIONS
AND TO KEEP THE ENGINE TURNED OFF.
1.
Find the OEM ECU: check
in your motorbike's workshop
manual where to find it. Press
the retainer clip of the OEM ECU
connector before pulling it: make
sure to remove the connector
without damaging it.
2.
Place and fix the support bracket
(if included) to insert RX1 Pro.
3.
Connect RX1 PRO to the OEM
connector. When supplied, use GET
adaptor connector. Make sure the
connector is properly plugged in, and
the retainer clip is fully engaged.
D. ACCESSORIES INSTALLATION
MAP SWITCH INSTALLATION
1.
Install
Switch on the handlebar.
EN
GET Map
6