Advertisement
Table of Contents
ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
PARTS LIST
PART
PART CODE
NO.
1
TGA65SG-CS01
2
TGA66SG-CS02
3
TGA65SG-CS02
4
62TGA65SGY101
You will need the following tools:
- Phillips Screwdriver (Not Included)
- Hex. Key Wrench (See Part #9)
Step 1:
Place the table top (#1) onto a non-abrasive
surface, such as a carpet, with its underside facing
up. Insert the legs (#2) and the supports (#3) into
the plastic holders attached on the underside of
the table top (#1) rim. See Figure 1.
Do not sit or stand on this table.
!
!
A weighted umbrella base must be used when using an umbrella with this table.
!
Do not discard any of the packaging until you have checked that you have all the parts and pack of fittings.
!
Keep children away during assembly. This item contains small parts which can be swallowed by children.
Children should always be under direct adult supervision while using the product.
Retain the assembly instructions for future reference.
!
DINING SET - TABLE
RONA CODE: 79275002
ITEM NUMBER: TGA65SG
INTENDED FOR RESIDENTIAL USE ONLY.
PART
Q'TY
1
TABLE TOP
4
LEG
2
SUPPORT
1
CENTER CONNECTOR
WITH RING
PAGE 1 OF 2
5
17C17D1302001
6
17C01D0710001
7
17FD05040301
8
1800337001
9
17KAA0101----Y4
FIGURE 1
COURTYARD CREATIONS INC.
2
SCREW ST4.2*10
12
BOLT M6*30
12
WASHER d6.5*D13*1.0
12
BOLT CAP M6
1
HEX.KEY WRENCH 4MM
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for UBERHAUS DESIGN TGA65SG
Summary of Contents for UBERHAUS DESIGN TGA65SG
- Page 1 ASSEMBLY INSTRUCTIONS DINING SET - TABLE RONA CODE: 79275002 ITEM NUMBER: TGA65SG ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE INTENDED FOR RESIDENTIAL USE ONLY. PARTS LIST PART PART CODE PART Q’TY 17C17D1302001 SCREW ST4.2*10 TGA65SG-CS01 17C01D0710001 TABLE TOP BOLT M6*30...
- Page 2 FIGURE 2 Step 2: Fasten the supports (#3) and the plastic holders on the table top (#1) by using screws (#5). See Figure 2. Step 3: Fasten the center connector with ring (#4) to the middle of the legs (#2) and supports (#3) by using bolts (#6) and washers (#7).
Need help?
Do you have a question about the TGA65SG and is the answer not in the manual?
Questions and answers