Advertisement
Quick Links
Testing the Remote Controller system
• Plug-in the power cord and turn-on the key
• Press and hold the button Up on remote controller for about 2 seconds.
The stand should start to move upwards and should stop after releasing
the button Up.
• Short press and release of button Up. The stand should start to move
upwards until the press of button Stop on remote controller before it
reaches upper limit position.
• Repeat the same procedure for button Down and Stop on remote
controller.
Unior d.d.
Kovaška cesta 10
3214 Zreče, Slovenia
T: +386 3 757 81 00
sales@unior.com
www.uniortools.com
1693EL.20
Remote control set
EN
Set za daljinsko upravljanje
SLO
uniortools.com
Advertisement
Related Manuals for Unior 1693EL.20
Summary of Contents for Unior 1693EL.20
- Page 1 Testing the Remote Controller system • Plug-in the power cord and turn-on the key 1693EL.20 • Press and hold the button Up on remote controller for about 2 seconds. The stand should start to move upwards and should stop after releasing the button Up.
- Page 2 Turn-off the power key and disconnect power cord Attach the antenna into the antenna holder. Install the controller back into the enclosure and fix it with four screws. Unscrew and pull out the controller module - remove four screws at the bottom of enclosure (no need to disconnect cables from controller, it can be left out of enclosure by hanging on the cables).