Page 2
E-mail: skope@skope.com Website: www.skope.com Trademark Infringement The SKOPE trademark on this product is infringed if the owner, for the time being, does any of the following: • Applies the trade mark to the product after its state, condition, get-up or packaging has been altered in any manner •...
HB80-2 1 Installation Safety First Always observe safety precautions when using any electrical appliance. Read these instructions carefully and keep them for future reference. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of...
HB80-2 Warning Should defrosting be necessary, turn off the refrigeration system and allow the ice to melt by air circulation. Do not use mechanical methods to remove ice, as this may damage the refrigeration circuit. Do not use any electrical appliances inside the food storage ...
HB80-2 Unpacking Remove all packing material from the inside and outside the cabinet, including the foam base and all adhesive tape holding the cabinet accessories. Shelves The cabinet is supplied with two shelves. Remove the packing material, then position the shelves into the cabinet at the desired heights. The bottom shelf has hooks on the back which lock the shelf in position.
HB80-2 2 Operation Cabinet Operation If the cabinet has been disconnected from the power supply for any reason, allow about 10 minutes before switching it back on. This allows the refrigeration system pressure to equalise before the system is restarted.
HB80-2 Loading The cabinet should be left running for 30 minutes to allow the cabinet to cool down before loading with product. When loading the cabinet shelves with product: Allow air space around all the product for even cooling and efficient ...
HB80-2 3 Maintenance Cleaning WARNING Disconnect the cabinet from the mains power supply before attempting any cleaning or maintenance. To ensure the chiller continues to run efficiently and reliably, perform routine maintenance. Time frames specified are indicative only. More regular cleaning and servicing may be required depending on cabinet placement and operating environment.
To prevent damage to the coil coating, use a soft brush. Condenser coil Servicing This refrigerator must only be serviced by SKOPE authorised service agents. Only SKOPE-authorised and supplied parts specified for this model may be used. Cabinet Light The cabinet interior light is non-serviceable and must not be tampered with in any way.
Need help?
Do you have a question about the HB80-2 and is the answer not in the manual?
Questions and answers