Page 3
Network of QUADRO Dealers. To ensure the safety, reliability and value of your scooter, and to maintain the validity of the warranty, use only original QUADRO spare parts and recommended lubricants.
Page 4
The information contained in this Owner's Handbook is provided as a guide only and may not be completely up to date due to modifi ca- tions which may be made by Quadro at any time for technical and/or commercial reasons, or else to comply with the legislation of the country in which the scooter is sold.
Quadro dealer immediately. try the vehicle is being driven in. We recommend always wearing a type- approved helmet, visor/goggles, gloves, overall and boots;...
When parking your scooter, ensure it is SAFE DRIVING left in a location where it is not likely to While driving, the driver must keep both be hit by other traffi c; it is also advisable hands on the handlebars and the pas- not to park the scooter on steep slopes, senger must hold onto the handles at uneven surfaces or on leaves, branches...
Quadro dealers, may result in your warranty lapsing and/or The scooter is equipped with scooter malfunctions. a parking brake; for correct use when parking/stopping the scoot- er, carefully read the “Parking...
This chapter describes the functions and COMPONENT LOCATION systems your Quadro4 is equipped with. Carefully reading the following pages will provide you with the knowledge to make the most of your scooter's potential. fi g. 1 1 - Handlebar controls, left-hand side. 6 - Integrated brake pedal (front and 2 - Integrated brake lever (front and rear).
HANDLEBAR CONTROLS, LEFT- HANDLEBAR CONTROLS, LEFT- Full-beam headlights HAND SIDE HAND SIDE With the key in position , turn selector The controls on the left-hand side of the A fi g. 2 to position 1 in order to turn on handlebar include: full beam headlights, the full beam headlights;...
HANDLEBAR CONTROLS, RIGHT- KEYS The steering lock does not HAND SIDE The scooter is supplied with two identi- engage automatically when the cal keys fi g. 6, which allow you to start The controls on the right-hand side of engine is shut off. the vehicle, engage the steering lock, the handlebar include: engine stop com- mand, hazard warning lights and engine...
• HTS (Hydraulic Tilting System) Move the scooter forwards and backwards in order to ensure LOCK/RELEASE LEVER that the parking brake is correctly The scooter is equipped with an oleo- engaged. pneumatic front and rear suspension system, known as HTS (Hydraulic Tilting System).
Tilting lock TEMPORARILY STOPPING THE STOPPING THE SCOOTER SCOOTER (WITH DRIVER ON If the scooter is stopped and left by the Placing lever A fi g. 10 in the 0 position BOARD) driver, they must: engages the tilting lock, preventing the If you simply bring the scooter to a halt, scooter from tilting.
INSTRUMENT PANEL A - Left group of indicator D - On-board computer dis- G - Engine coolant temperature gauge lights play H - Right group of indicator lights B - Speedometer E - ADJ selection button C - MODE selection button F - Rev counter...
ON-BOARD COMPUTER Trip Computer function In order to set the clock: 1. Press the ADJ selection button to Press the ADJ button to view the odom- increase the hours TRIP TRIP eter, Trip A, Trip B function. 2. Press the MODE selection button to change to setting the minutes 3.
Page 19
INDICATOR LIGHTS ON THE INSTRUMENT PANEL SYMBOL DESCRIPTION Hazard warning lights MEANING This indicator light turns on when the hazard warning lights are activated. Battery MEANING With the key in the position, this warning light turns on when the battery voltage falls below 12V. WHAT TO DO Recharge the battery, or replace it if necessary.
Page 20
WHAT TO DO Take your scooter to an authorised Quadro dealer, who will service it following the Planned Mainte- nance Plan and then reset the indicator light. Malfunction Indicator MEANING The warning light detects the faults in the engine monitoring system.
Page 21
SYMBOL DESCRIPTION Fuel reserve MEANING With the key in the position, this indicator light turns on to notify the driver that it is necessary to refuel as soon as possible. Dipped headlights MEANING With the key in the position, this indicator light turns on when the dipped headlights are turned Turn signals MEANING With the key in the...
INTEGRATED BRAKE PEDAL REAR-VIEW MIRRORS REAR FOOTRESTS The integrated brake pedal A fi g.12 is To adjust the rear-view mirrors fi g. 13, located on the right-hand driver footrest. move them manually to the required To open it, press the upper part of the position.
Storage compartment below seat EQUIPMENT Electrical sockets Storage compartments Quadro4 is equipped with two 12 V To access the storage compartment power (cigarette lighter) sockets. below the seat fi g. 16: Quadro4 is equipped with two storage • Turn the key to the right, to the compartments A and B fi...
(or press the brake 4 - ON. pedal) and press the starter button 5 - Seat opening. B fi g.2. fi g. 2 fi g. 1 If you are not able to start the scooter, consult an authorised Quadro dealer.
ENGINE STOP PARKING You can switch off the engine as fol- When it is necessary to park the scoot- Never start scooter lows, always and only with the scooter er, as well as performing the engine with the accelerator control fully stopped: stop procedure described in the previ- open, as this could cause a loss of...
REFUELLING PERIODS OF INACTIVITY Proceed as follows to access the fuel If the scooter will not be used for a long Always turn the engine off fi ller cap: period of time, we recommend you when refuelling. Petrol is highly •...
Page 30
Owner's Handbook Quadro 4 and keep it in good working will guarantee perfect operation and a and tilting lock engaged. order, as well as ensuring it retains its long lifetime for your scooter.
Page 31
Do not operate the scooter It is recommended you have with a low oil level or dirty oil, as an authorised Quadro dealer or this could cause irreparable dam- service centre perform this check. age to the engine.
Page 33
• engine cold and the scooter on a level Remove cover A fi g. 2 by unscrew- authorised Quadro dealer or service surface. ing screws B and C centre • •...
Page 34
Dry the surfaces coolant with the specifi cations level is at or below the minimum listed in the “Products” section in level, have an authorised Quadro When washing the mechanical parts the “Technical Data” chapter. dealer or service centre top it up.
Page 35
Clean the vehicle more frequently if you regularly drive on gritted/salted roads. Do not use sponges or Do not use strong deter- cloths which have come into gents or any type of harsh chemi- contact with abrasive chemical cal product (degreasers etc.) for products, solvents, thinners, rust cleaning the windscreen.
Page 36
• Correct operation of external The Programmed Maintenance service Perform the following checks: lighting is performed by the Quadro service • • Engine oil level Check condition and wear of brake network or qualifi ed workshops. pads (front and rear) Any operations outside of the Mainte- •...
Page 37
PLANNED MAINTENANCE PLAN The annual checks must be performed every 12 months, unless the mileage interval is reached fi rst. Check (cleaning and replacing if necessary) the air fi lter and the variator case air fi lter more frequently if the scooter is used in very humid or dusty environments.
Page 38
Odometer reading (km x 1000) Annual Part Operation to be carried out checks Odometer reading (miles x 1000) Variator rollers Check and replace if necessary Variator case air fi lter Clean or replace if necessary ...
Page 39
Odometer reading (km x 1000) Annual Part Operation to be carried out checks Odometer reading (miles x 1000) Check for correct operation, adjust sup- HTS switch port if necessary Check for correct operation, adjust sup- ...
Page 40
Odometer reading (km x 1000) Annual Part Operation to be carried out checks Odometer reading (miles x 1000) Lights, signal, switches Check operation (*) On reaching 40000 km, checks must be repeated starting from the 5000 km interval Engine oil: use SAE10W40 or SAE10W50.
Page 42
• Remove the blown fuse Never repair blown fuses; • Replace the blown fuse with one of see a Quadro dealer to have the the same rating, positioning it in the component(s) replaced same slot • Close the fuse cover...
Page 43
Table of fuses Refer to fi gure 2 AMPERAGE CONNECTED LOAD Battery charger circuit General Lights Spare Spare Spare fi g. 2...
Page 44
Replacing Bulbs Replacing Bulbs • Remove the complete bulb-bulb holder assembly A fi g. 6 from the See an authorised Quadro See an authorised Quadro plastic cover dealer or service centre if a bulb dealer or service centre if a bulb...
Page 45
Quadro4 is fi tted with Tubeless tyres. battery: the bulb holder B. • Remove cover A fi g. 8 by unscrew- ing screws B and C See an authorised Quadro dealer or service centre for tyre replacement. fi g. 7 fi g. 8...
Page 46
• Extract the cover of the HTS lock/ Recharging the battery release lever To disconnect the battery, follow the • Unscrew screw A fi g. 9 and remove procedure described in the “Replacing the bracket B, then extract the the battery” section in this chapter, then battery C from its seat connect the battery charger.
Page 47
The engine will not start E. Air or fuel filter clogged E. See an authorised Quadro centre or qualified workshop for cleaning F. Remove the spark plug and vaporise fuel inside the cylinder. See an authorised Quadro centre or F. Clogged engine qualified workshop G.
Page 50
This chapter contains all vehicle identi- SCOOTER IDENTIFICATION Engine number fi cation data as well as technical char- acteristics such as its weight, pressures, The engine number is stamped on the dimensions etc. Frame number crankcase A fi g.2. The frame number is punched under the right-hand footrest, fi...
Page 51
ENGINE CHARACTERISTICS PRODUCTS Type 4-stroke Engine oil SAE 10W40 or SAE 10W50 No. of cylinders Final drive oil 85W140 GL-5 or equivalent No. of valves Engine coolant PARAFLU-UP Cylinder Arrangement Single, forward-facing cylinder Braking fl uid DOT4 Cooling Liquid Unleaded petrol, min. 95 RON octane Fuel rating.
Page 53
DIMENSIONS Reference Description Value (mm) Overall length 2200 Wheelbase 1580 Total height (to cowl) 1340 Seat height Distance from ground Front track Rear track Total width (at handlebars) Dimensions are given in millimetres and refer to the scooter equipped with the original tyres. The height refers to the scooter when unloaded.
Page 54
BRAKING SYSTEM WEIGHTS AND LOADS Unladen mass (including engine oil, Type Disc brakes, 2 front, 2 rear 269 kg fi nal drive oil, engine coolant) Disc diameter 240 mm Mass in running order 279 kg CLUTCH Passenger capacity 2 (driver + passenger) Type Automatic dry centrifugal Maximum permissible load...
Page 58
Any total or partial use of the contents of the present booklet is prohibited, as well as the reprinting, storage, reproduction, editing, release or distribution of the content themselves by means of any technological platform, support, or computer network without written permission of QUADRO VEHICLES S.A. company.
Need help?
Do you have a question about the Quadro4 2017 and is the answer not in the manual?
Questions and answers