Table of Contents
Advertisement
Choose the door opening direction by
turning the cupboard 180°.
1.2 Installation
The assembly procedure depends on the type of your appliance. There are three
types of installation:
1. Cabinets with the plastic top and hinge on the top.
2. Cabinets without the plastic top, with hinge and cover on the top.
3. Cabinets without the plastic top, without hinge and cover on the top.
Type 1
1
470 mm
3
2
4 mm
1. Drill 3,5 mm holes in the rear corners
of the appliance on the pre-marked
positions.
2. Screw the two steering screws in (B).
Do not tight them fully.
3. Attach the double-sided tape (E) to
one of the assembly brackets (D).
Fasten the bracket to the plastic top
of the appliance in the front, on the
side without the hinge. Refer to the
measurements on the picture. For ex‐
tra security you may use the steering
screw (B) to fix the bracket.
Turn the cupboard and place it on the ap‐
pliance, to let the door open in the de‐
sired direction.
Some models have a pre-as‐
sembled bracket in the front,
on the side without the
hinge . Dismantle it, cut the
end carefully and fix the
bracket again. For these
models, additional assembly
bracket (D) is not needed.
ENGLISH
3
Advertisement
Table of Contents
