ACO INS-ACC-60 Operation And Installation Instructions

OPERATION AND INSTALLATION INSTRUCTIONS FOR INS-ACC-60 STANDALONE

The

INS-ACC-60 is a standalone proximity key fob reade

y means of key fobs stored in the reader's memory. The output can be used to control external devices such as: reversible

E-lock or relay. The reader is installed in a standard 060 mm electrical box or can be surface-mounted using an optional box

to be purchased separately.

INS-ACC-60 supports up to 6144 key fobs, assigned in the same way as with other Aco products of the CDNP7ACC and

INSPIRO+ series (any number of key fobs assigned to each apartment, including the master and installer's key fobs). The

reader also supports simple adding of key fobs using the master key fob (without having to connect it to a PC) or advanced

adding and managing of key fobs via ACC_v73 software (version v7.3 or higher) which can be downloaded free of charge

from

www.support.aco.com.pl

INS-ACC-60 signals the output activity (such as door opening) by a sound signal (built-in buzzer, which can be

switched off using the computer software).

1. TECHNICAL PARAMETERS

Power supply: 12V-15V DC; 40mA (without output load)

Power consumption in standby mode: ~0.3W

Output current capacity 1A max. (0.5 A for reversible E-lock)

Output control method: pulse short-to-ground (for E-lock) or permanent short-to-ground (for relay/gate)

Maximum number of cards/key fobs: 6144

Card/key fob reading standard: Unique 125 kHz

ACO Sp. z o.o. sp. komandytowa, 62-002 Suchy Las, ul. Diamentowa 7, tel./ fax 61 843 93 71

PROXIMITY FOB AND CARD READER

r i

(use a CDN-USB cable to connect the reader with a PC, to be purchased separately).

www.aco.com.pl

n Unique 125 kHz standard. The dev

ice is designed t

ol one outpu

o contr

Table of Contents

Do you have a question about the INS-ACC-60 and is the answer not in the manual?

Page 1 INS-ACC-60 supports up to 6144 key fobs, assigned in the same way as with other Aco products of the CDNP7ACC and INSPIRO+ series (any number of key fobs assigned to each apartment, including the master and installer’s key fobs). The reader also supports simple adding of key fobs using the master key fob (without having to connect it to a PC) or advanced adding and managing of key fobs via ACC_v73 software (version v7.3 or higher) which can be downloaded free of charge...
Page 2 2. MOUNTING Flush-mounted version The standard installation box Φ60 mm is flush mounted so that the mounting holes 1 are level. We insert cables through the holes in the box. Connect the reader according to the diagram further in this manual. The set includes TX10 key and two screws 2 used for fixing the reader module to the box.
Page 3 CDNP7ACC or INSPIRO+ panels. The PC software can also be used to upload key fobs from the file which was created as a backup of stored key fobs from any Aco device featuring a proximity card/key fob reader, otherwise referred to as ACC.
Page 4 ("USB cable connected"), then when connection with reader is established, the rectangle should change into green and the message "Connected with INS-ACC-60 module” should appear next to it - or “connection to the module not established” will be displayed if connecting the module failed (such as due to transmission error or damage).