Related Manuals for CONEN Rail 2.0
Summary of Contents for CONEN Rail 2.0
- Page 1 PYETVBWW2RN.. ASSEMBLY INSTRUCTION Rail 2.0 Electrical height adjustable wall mounted pylon system including side wings for 65-86" Displays...
-
Page 2: Package Contents
PACKAGE CONTENTS 10/11 10/11 20 15 20 4 24/25 2 x Pylon column 2 x Cross braces 2 x Mobile wing 1 19 2 x Pylon sledges 1 x Display frames 2 x lateral stoppers 1 20 2 x Double sliding block 1 x Upper/lower bar right 1 10 4 x Caps... -
Page 3: Mounting Instructions
PACKAGE CONTENTS 4 x M5 x 55 mm 4 x 8 mm 2 x 190 mm 22 x M8 Mounting plate right Mounting plate left Spax screw Dowels Z-Angle Sliding block Self-locking nut 10 x M6 x 20 mm 42 x M6 8 x M10 4 x M3,5 x 16 mm 4 x M10 x 40 mm... - Page 4 MOUNTING INSTRUCTIONS Wall mounting material not included Optional available (If floor mounting ist not possible.) Optional Do not tighten the nut...
- Page 5 MOUNTING INSTRUCTIONS Please check the sliding movement so that the dis- play does not hit the ceiling. If necessary, correct the positi- on of the double sliding block or mounting plate The position of sliding block , resp. mounting angle sets the lowest position of Tighten the nut the movement.
- Page 6 MOUNTING INSTRUCTIONS Do not tighten the nut Tighten the Align with a water level Do not tighten screws...
- Page 7 MOUNTING INSTRUCTIONS Do not tighten the nut Do not tighten the nut 10/11...
- Page 8 MOUNTING INSTRUCTIONS 10/11 This step twice! 10/11 10/11 10/11 Tighten the screws...
- Page 9 MOUNTING INSTRUCTIONS Tighten all screws! 10/11...
- Page 10 MOUNTING INSTRUCTIONS Optional – without anti-collision Cable routing rear...
- Page 11 MOUNTING INSTRUCTIONS 18 32 With anti-collision Sensor and cable routing at the rear 18 33 Passepartout...
- Page 12 MOUNTING INSTRUCTIONS Passepartout Passepartout 24/25 24/25 10/11...
- Page 13 MOUNTING INSTRUCTIONS...
- Page 14 MOUNTING INSTRUCTIONS Align the suspension rails as centrally as possible to the display!
- Page 15 MOUNTING INSTRUCTIONS Down Display Keypad Set up presets – Move the column to the desired position, then press the button until the display flashes. Now press the number . The display shows you the occupied memory space (e.g. P1) and the saving process is completed. Is the number not pressed within 3 seconds, the saving process is aborted.
-
Page 16: Troubleshooting
TROUBLE SHOOTING System is pre-calibrated. PLEASE RECALIBRATE ONLY IN CASE OF ERROR. SYSTEMS WITH ANTI-COLLISION Press key simultaneously until you hear 1 x audio signal Press key until you hear 3 x audio signal Press key and hold on until the column reached the maximum position and you can hear 2 x audio signal. -
Page 17: Instructions For Disposal
MOUNTING REGULATIONS IMPORTANT HAZARD & SAFETY NOTES Please carefully read the below hazard and safety notes before using the height adjustment unit. This adds to make the unit work failure-free and avoids accidents. ELECTRICAL SAFETY Connect unit to a free accessible 110 – 230 V / 50 Hz grounded power outlet only. Make sure, the unit can be immediately separated from the power outlet.
Need help?
Do you have a question about the Rail 2.0 and is the answer not in the manual?
Questions and answers