Related Manuals for Boss Snowplow MSC14175
Summary of Contents for Boss Snowplow MSC14175
- Page 1 Form No. MSC14176 Rev A Owner's Manual Plow Side Kit Groundsmaster ® 360/7200/7210 Part No. MSC14175—Serial No. 400000000 and Up *MSC14176* A Register at www.bossplow.com. Original Instructions (EN)
- Page 2 This product complies with all relevant European directives; for details, please see the separate product specific Declaration of Conformity (DOC) sheet. BOSS Products limited consumer warranty and BOSS Products commercial warranty policies are located at www.bossplow.com. Patents www.ttcopats.com. Introduction Note: This plow attaches to the Groundsmaster 7200 or 7210 with the Polar Trac kit or the Groundsmaster 360 with the Quick-Attach System.
-
Page 3: Table Of Contents
Contents Safety Improper use or maintenance by the operator or Safety ............... 3 owner can result in injury. To reduce the potential Preparation............3 for injury, comply with these safety instructions Operation............3 and always pay attention to the safety-alert Safety and Instructional Decals ...... -
Page 4: Safety And Instructional Decals
• Keep your hands, feet, and clothing away from causes distractions; otherwise, injury or property moving parts and mounting points. damage may occur. • • Use your full attention while operating the Do not operate the plow within 8 m (25 ft) of machine. -
Page 5: Setup
Setup Note: Determine the left and right sides of the machine from the normal operating position. Preparing the Machine Remove the Attachment from the Machine (if required) Refer to the attachment Installation Instructions. g324607 Figure 4 Installing the Required Kits Torque all 4 bolts to 203 N∙m (150 ft-lb). -
Page 6: Installing The Plow Onto The Machine
Installing the Plow onto the Machine Move the machine into position behind the attachment adapter. Raise the machine adapter into the attachment adapter. Insert the locking pin through the adapters and secure it with a hairpin cotter. g324610 Figure 7 Groundsmaster 360 with the Quick-Attach System g324611 Figure 8... -
Page 7: Installing The Hydraulic Hoses
Installing the Hydraulic Product Overview Hoses Install the hoses to the quick disconnect fittings. g324606 Figure 10 1. Trip springs 4. Locking pin 2. Hydraulic hose quick 5. Cotter pin couplers 3. Attachment plate g324609 Figure 9 Controls g268384 Figure 11 Groundsmaster 360 with the Quick-Attach System 1. -
Page 8: Specifications
Operation Operating the Plow Refer to your machine Operator’s Manual for instructions on operating attachments. Operating Tips • Become familiar with the area you are plowing; hidden obstructions such as curbs and pipes can damage your plow or machine. • Do not let snow accumulate;... -
Page 9: Maintenance
Maintenance Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Tighten all hardware. After the first 2 hours • Check the hydraulic cylinders. • Check the hydraulic lines and hoses. Before each use or daily • Check all fasteners, pins, retainers, nuts, and bolts. •... -
Page 10: Troubleshooting
Troubleshooting Problem Possible Cause Corrective Action Oil leaks from the hydraulic cylinders. 1. The hose is bad. 1. Check the hose for leaks. Apply thread locking compound to the connection or replace the hose. 2. The cylinder is bad. 2. Replace the cylinder. 3. - Page 11 Notes:...
Need help?
Do you have a question about the MSC14175 and is the answer not in the manual?
Questions and answers