Costco 1900376 Quick Start Manual

WARNING:

THIS SEASONAL PRODUCT IS NOT INTENDED FOR PERMANENT INSTALLATION OR USE.

For decoration only, not intended for use by children.

Do not mix old and new batteries.

Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium or other types) batteries.

Do not use rechargeable batteries in this product.

Remove batteries from product during periods of non-use. Remove exhausted batteries from the light set immediately. Battery leakage can
cause corrosion and damage to this product.

Avoid short-circuiting the terminals of the batteries.

Batteries should be inserted following the correct polarity markings on the product.

Non-rechargeable batteries should not be recharged.

Only batteries of the same or equivalent type as recommended shall be used. Replace only with "AA" type batteries.

Dispose of batteries safely. Do not attempt to burn them. Use collection points where available. Follow directions on batteries.

Make sure battery compartments are securely closed.

Always replace the whole set of batteries at one time, taking care not to mix old and new ones or batteries of different types or brands.

Retain these instructions for future reference.
Battery Installation and Operation:
These lights are intended for Indoor and Outdoor use.
This Product requires 2 "AA" 1.5V batteries (not included). Use only with new Alkaline Batteries for best performance and longest operation.
Carefully remove the product from its packaging.
-
Make sure the light strings and wires are completely unraveled and positioned so it does not present a snagging or tripping hazard.
-
Gently lift up the two tabs on side of battery case, and open the access door.
-
Clean the battery contacts and also those of the device prior to battery installation.
-
Insert 2 new "AA" batteries of the same brand matching the polarity shown inside the battery compartment.
-
Close the cover and secure with the latching tabs.
-
Press the Power Button to turn on the lights (see Button Operation section below for switch operation) and press the Function Button to cycle
-
through the functions.
Note: This product contains non-replaceable bulbs, do not attempt to replace bulbs.
-
Button Operation:
Power button:
1) TIMER – Lights cycle 6 hours on and then 18 hours off.
2) ON – turns on lights.
3) OFF – turns lights off.
To set the unit to Timer mode, press the Power Button until the set turns off, the next button press will turn on the Timer. It will light up for 6
-
hours when turned on, and then switch off for 18 hours to conserve battery power. The Timer function resets each time the light set is turned
off using the Power Button.
Function Button:
Press the button to switch between the 8 functions
Function Button
1. STEADY WHITE
2. STEADY MULTI
3. FLASH WHITE
4. FLASH MULTI
5. FADE WHITE
6. FADE MULTI
7. FLASH WHITE-
MULTI
8. FADE WHITE-MULTI
ITM. / ART. 1900376 (US/CA/TW)
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
Power Button
1. TIMER
2. ON
3. OFF
LED Micro Lights