Download Print this page

ETI 822-800 Quick Start Manual

Water bath

Usage and product properties

• The Water Bath Insulation Balls are to be used in conjunction with the water bath.

• They are placed on the water surface, in order to reduce the loss of water

through evaporation and heat.

• Item supplied: 250 insulation balls (average diameter approx. 20 mm) in a

storage bag.

• Heat resistance: up to 90˚C (floating in the water)

• Material: PP (Polypropylene)

DANGER! Risk of injury through burning

Avoid splashes of hot water when adding and removing the insulation balls and

avoid contact with hot water.

WARNING! Risk of material damage

Keep the insulation balls away from objects over 100˚C, such as a hot plate.

PLEASE NOTE: Take into account that the water levels in the container will raise

somewhat when the insulation balls are added.

1. Before heating up: place as many insulation balls in the water bath, so that the

surface is completely covered with one layer of balls.

2. After use: let the water cool down, before you remove the insulation balls from

the Water Bath, alternatively use a ladle or similar to remove them.

Water Bath

Insulation Balls

Product Information

Product code:

822-800

Table of Contents

Do you have a question about the 822-800 and is the answer not in the manual?

Page 1 Insulation Balls Product Information Product code: 822-800 Usage and product properties • The Water Bath Insulation Balls are to be used in conjunction with the water bath. • They are placed on the water surface, in order to reduce the loss of water through evaporation and heat.
Page 2 Cleaning and storage • Rinse the insulation balls with clean tap water. • If required, the insulation balls may be cleaned in mild dishwater. Rinse them with clean water afterwards. • Let the insulation balls dry completely before storing them in the storage bag. Supplied by Electronic Temperature Instruments Ltd Worthing ·...