A. Adjustment of TTL type before use ................4 B. Adjustment of Flip-Up type before use ..............7 5. Operating Instruction ..................9 6. Precaution ..................... 10 7. Warranty ......................11 Appendex 1. TTL & Flip-Up Frame Figure ............... 13 Looks Series (Surgical Telescope) www.xenosys.co.kr...
Notice: The manual should change without fore-notice to introduce improved products. 1. Product Introduction The Looks series is medical equipment with Optic device to magnify the wound, and is designed by mounting 2 surgical telescopes on eyeglass lens (TTL type) or frame (Flip-Up type). TTL type has Looks2500, Looks2800, Looks3200, Looks3500 &...
⑥ Side Shield 2EA (Not visible, Not for Flip-up type) B. Checking Component quality: Looks Series should be fabricated, fully tested and adjusted by our quality standard and personal prescription. If you find out any defectives or brokerage by careless handling and force majeure in transportation, please call to our customer center or sales representatives.
Page 5
④ When you lower the frame and the axis to get clear image, spread the nose pad or bend the end-pieces of temple arms upward and recheck the image. Bend up Spread Nose-pad Adjustment of Frame Left Image Right Image Adjustment End-piece Looks Series (Surgical Telescope) www.xenosys.co.kr...
Page 6
③ If the image is blurred or vignetted through telescope as following figures, adjust the frame rightward, the axis of telescope lens & the nose pad for fitting. Right side Left Image Right Image Nose-pad Adjustment Looks Series (Surgical Telescope) www.xenosys.co.kr...
(already installed) in the product with your prescribed eyeglass lens. When replacing with the prescribed eyeglass lens, the flip-up system shall be separated first, and fabricated again after replacing the eyeglass lens. Separation of flip-up system Looks Series (Surgical Telescope) www.xenosys.co.kr...
Page 8
(-) groove (part A) about 30°counterclockwise by using the (-) type driver. Lock or unlock the PD And then, please tighten the knob by turning clockwise after adjusting the PD adjusting knob (part B). Looks Series (Surgical Telescope) www.xenosys.co.kr...
B. If your telescope is equipped with side shields, place the shield over temple. (Optional) Not provided in Flip-Up type. Installation to PT Installation to HT Frame Frame Push Push Push Completed Insert → Completed Fit side shield in temple → Fix by Stopper → Completed Looks Series (Surgical Telescope) www.xenosys.co.kr...
Call the local sales representatives to repair our telescope F. Do not walk around with the telescopes on, be sure to take them off or flip up when walking around. Looks Series (Surgical Telescope) www.xenosys.co.kr...
Page 13
⑦ End piece: hold when bending hinge corners or adjusting the width of two temples. 2. Flip-Up Frame ④Temple ②Flip-up hinge ①PD knob ③Glasses lens ① PD Knob: Adjust Pupilary Distance. ② Flip-up Hinge: Allow you to flip up your telescope for normal vision Looks Series (Surgical Telescope) www.xenosys.co.kr...
Page 14
③ Glasses lens: Replace with the lens having your eye correction (Refer to Page 7. Replacement of Eyeglass lens) ④ Temple: Adjust for additional & better fitting Looks Series (Surgical Telescope) www.xenosys.co.kr...
Need help?
Do you have a question about the Looks Series and is the answer not in the manual?
Questions and answers