GE UCC15NP Owner's Manual page 22

Care And Cleaning
MODEL UCC15NP*
Cleaning the ice machine involves adding a cleaner to
the ice machine.
You should use rubber gloves when using the scale
remover. To order cleaner, go to GEApplianceParts.com
or call 877-959-8688. Order part number WX01X40745.
1. Pour 3 ounces of cleaner into the squirt bottle.
batch of ice is released. This could take up to 30
minutes.
3. Scoop out and discard all of the ice in the ice bin.
Clean button for 3 seconds to begin cleaning
function. The Time to Clean light will start to flash.
5. After the Time to Clean light starts flashing, add the
3 ounces of cleaner from the squirt bottle as shown.
Winterizing
the door and push the Power button to turn the ice
the current icemaking cycle is completed (up to 20
minutes) and the icemaker tank will automatically
drain. (Make sure to turn off the icemaker in this way.
the water in the tank will not drain.)
2. Turn off the water supply.
Vacation
time, it is recommended that you turn off icemaking.
22
Power button for 3
6. The icemaker will continue the cleaning process.
This can take up to one hour. When the process is
complete, the Time to Clean light will turn off.
7. Pour approximately 1/2 gallon of hot (95-115°F)
water into the bin to flush out the bin.
8. Mix one ounce of cleaner with one quart of water
and clean the ice bin, interior door and gasket
surfaces.
ounce of household bleach with 2 gallons of water
into the bin.
10. Rinse the bin again with hot water.
11. Push and hold the Power button for 3 seconds to
restart ice making.
The ice scoop should also be washed regularly.
3. Models with a drain pump installed should have about
into the ice storage bin drain.
NOTE:
4. Turn off and unplug the machine.
NOTE: When placing the icemaker back in service
cleaning process on page 21.
the icemaker to complete the icemaking process prior
to turning off. The icemaker will also drain any water
in the tank every time it is turned off.
49-1000640 Rev. 0