Equinox Systems SH-1 User Manual page 48

NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
This product meets the government's requirements for exposure to radio waves. The guidelines are
based on standards that were developed by independent scientific organizations through periodic
and thorough evaluation of scientific studies. The standards include a substantial safety margin
designed to assure the safety of all persons regardless of age or health. The SAR limit of USA
(FCC) is 1.6 W/kg averaged over one gram of tissue for body, and 4 W/kg averaged over ten gram
of tissue. Device: Equinox Media Home Bike Tablet (FCC ID: 2AUTU-SH-1) has also been tested
against this SAR limit. SAR information on this and other pad can be viewed on‐line at
http://www.fcc.gov/oet/ea/fccid/. Please use the device FCC ID number for search. This device
was tested typical 0mm body. To maintain compliance with FCC RF exposure requirements, use
accessories should maintain a separation distance between the user's bodies mentioned above, the
use of belt clips, holsters and similar accessories should not contain metallic components in its
assembly, the use of accessories that do not satisfy these requirements may not comply with FCC
RF exposure requirements, and should be avoided.
For 5.2G WLAN, it is restricted to indoor use only
48