Page 2
Defective product should be clearly marked or stored where it cannot be used again by mistake. Failure to retain the product may impede hOme ™ ’s ability to correct any legitimate problem ™ and may limit the extent to which hOme may provide recourse.
Page 3
Congratulations on bringing home your new appliance! Don’t forget to register your product at homelabs.com/reg for updates, coupons, and other relevant information. Although greatly appreciated, product registration is not required to activate any warranty.
Important Safety Instructions • READ AND SAVE THESE INSTRUCTIONS. • Always disconnect the appliance before any cleaning or maintenance. • CAUTION: Place the appliance and connected cord WELL so that the appliance is not likely to be upset and cause fire, electric shock, or injury to persons. •...
Page 5
Understanding Your Humidifier Accessories Diffuser Pad × 5 Power Cable Filter Brush Install the Float Pad to Control Water Flow Float pad is a controller of water flow from water tank on ultrasonic chip. Insert the float pad into 1 and press securely into the slot of 2.
Page 6
Understanding Your Humidifier Parts Overview Top Cover Water Tank Cover Nozzle Diffuser Pad Aroma Tray Water Tank Handle Mist Outlet Water Tank Main Body Power Button Touch Panel Timer Indicator Sleep Indicator Spraying Indicator Water Level Indicator Filter Filter Cover...
Page 7
Operating Instructions Position the appliance Place the Ultrasonic Humidifier on an elevated surface (i.e. a table) around 23.6 in height as the below figure shows. 39.4” 11.8” 11.8” 11.8” Fill water • Remove water tank cover and fill the tank with water. Make sure the water level does not exceed the max-level line.
Page 8
Operating Instructions Power on / off • Connect the power cable to the back of the humidifier and then plug into a socket. • To power on the humidifier, tap the power button. The water level indicator shows the water level. You can start to operate the touch panel.
Cleaning and Maintenance • Always disconnect the device before any cleaning or maintenance. • Drain the water out of the device. • Place the device parts at ventilating place to dry completely. • Clean the device regularly to ensure good performance. •...
Troubleshooting PROBLEMS SOLUTIONS Check to see if there is enough water in the tank. Fill with cool “My device is on but it’s water. not producing enough mist.” Make sure your device is placed on a level surface. The water level where the ultrasonic chip is located is too high. Take out the water tank, pour the water out, clean the silicon inside the water tank, and check to make sure the float is not reversed.
(“warranty period”) on all of our products purchased new and unused from hOme Technologies, LLC or an authorized reseller, with an original proof of purchase and where a defect has arisen, wholly or substantially, as a result of faulty manufacture, parts or workmanship during the warranty period.
Need help?
Do you have a question about the HME020390N and is the answer not in the manual?
Questions and answers