Advertisement
Quick Links
Copyright 2005, 2006 Gary B. Anderson, All rights reserved
Zenith Aircraft
ZODIAC 601
Cut along leading edge of vertical
●
stabilizer
Cut out
Cut along four lines above canopy in front
●
and in back
Fold paper inward between fuselage
●
halves.
Main Spar and Main Gear
Advertisement
Summary of Contents for Zenith Air ZODIAC 601
- Page 1 Copyright 2005, 2006 Gary B. Anderson, All rights reserved Cut along leading edge of vertical ● stabilizer Cut out Cut along four lines above canopy in front ● and in back Fold paper inward between fuselage ● halves. Zenith Aircraft ZODIAC 601 Main Spar and Main Gear...
- Page 2 Builders Manual Zenith Aircraft Company CH 601 Paper Airplane...
- Page 3 Fold paper in half. Fold paper in half. Take care that the Take care that the fold is symmetrical. fold is symmetrical. A trick to doing this A trick to doing this is to back light the is to back light the paper and line up paper and line up the wing panels...
- Page 4 Fold spar in half again. Wing spar and wheels Fold fuselage tabs along fuselage to both sides. Fuselage tabs STOL Zenith Aircraft Company Revision 0.0 (09/22/07) Wing Spar and Fuselage Tabs © 2007 Gary B. Anderson Page 3 CH 601 www.zenithair.com...
- Page 5 Fold forward fuselage tabs inward. Forward fuselage tabs Fold rearward fuselage tabs inward. Rear fuselage tabs STOL Zenith Aircraft Company Revision 0.0 (09/22/07) Fuselage Tabs © 2007 Gary B. Anderson Page 4 CH 601 www.zenithair.com...
- Page 6 Fold wings and horizontal stabilizer outward. Tape edges of fuselage. Fold wings and horizontal stabilizer Bend gear legs down and place spar and gear on tape. Main spar and gear legs STOL Zenith Aircraft Company Revision 0.0 (09/22/07) Wings and Main Gear ©...
- Page 7 Tape spar and gear to wing as shown. Tape spar and gear to wing Tape front gear to strengthen as shown. Front gear STOL Zenith Aircraft Company Revision 0.0 (09/22/07) Main Spar and Gear © 2007 Gary B. Anderson Page 6 CH 601 www.zenithair.com...
- Page 8 Acquire an engine. The CH 601 requires three paper clips. Place engine on cowling alternating the smaller loop side to side. Engine Form the leading edge of the wing. Use a sharp straight edge to make three creases in the leading edge.
- Page 9 The leading edge should look like this. Leading edge profile Bend down the flaps a bit. Bend up the elevators a bit and you are ready to fly! Trim STOL Zenith Aircraft Company Revision 0.0 (09/22/07) Leading Edge and Trim ©...