Advertisement
DELL SE2216H/SE2216HV/SE2216HM
S7
Use Philips-head screwdriver
remove PCBAs screws.
M3 x 5 (5pcs for VGA connectivity) & M3 x 6
for ground screw.
Torque = 6.0 kgf +/-0.5 kgf
S8
Take out Power Board and Interface Board
from chassis.
Remove cable from IF & power board.
S9
Remove mylar (as yellow)
Use Philips-head screwdriver
remove 3 screws from Keypad board
T2 *3. Torque: 1.0 +/- 0.1Kgf.cm
(
S10
Φ5 mm) to
S11
S12
(
Φ3 mm) to
Remove electrolyte capacitor >25mm height
mark)
from printed circuit boards.
Cut the glue between bulk cap and PCBA with knife
– ensure cutting path within the glue, don't touch
bulk cap and PCBA.
Remove electrolyte capacitor >25mm height
mark)
from printed circuit boards.
Cut the glue between bulk cap and PCBA with knife
– ensure cutting path within the glue, don't touch
bulk cap and PCBA.
Lift the bulk capacitor away from power board.
(red
(red
2
Advertisement
