Fm (Rds) Operation - Hertz Marine HMR 15 Owner's Manual

9.2 Radio Operation
Select Tuner as Playing Source
Press SRC button to select the Tuner mode.
Global Tuner
This unit is initially set to USA frequency intervals of 10KHz for AM and 100KHz for FM.
When using it outside the USA, the frequency reception range can be switched to the intervals below.
AM
FM
Select the Radio Band
Press BAND button to select one radio band from FM1, FM2, FM3, AM1, AM2.
Preset station selection
- short press SEEK - to move to the previous preset.
- short press SEEK + to move to the next preset.
SEEK Tuning
- long press SEEK - to SEEK the previous strongest station.
- long press SEEK + to SEEK the next strongest station.
Manual Tuning
short press AS button to enter manual tuning.
- the display shows MANUAL (the system reverts to AUTO mode after a few seconds if no button is pressed).
- press SEEK - or SEEK + to manual tune the desired frequency (the system reverts to AUTO mode after a
few seconds if no button is pressed).
Auto Store
Only stations with sufficient signal strength will be detected and stored in the memory.
Press and hold the AS button to automatically find the first 18 strongest stations and store them into presets.
The new stations replace any stations already stored in the band.
Save a preset
Tune the desired station / frequency and then press and hold
Use the SEEK buttons to select desired preset number then long press
USA
Standard
Frequency
10KHz
spacing
Frequency
530 - 1710KHz 522 - 1620KHz
range
Frequency
100KHz
spacing
Frequency 87.5 -
range 107.9MHz
Europe
Standard
9KHz
50KHz
87.5 - 108MHz
button, the preset number starts to blink.
button to save it.
Owner's Manual
11